AMX NXA-WAP250G manual Network Settings PPPoE Settings

System Configuration

DHCP Server/NAT Setting: Enables or disables the DHCP server and NAT on the

WAP250G. (Default: Enabled)

Start/End IP Address: Specifies the start/end IP address of a range that the DHCP server can assign to DHCP clients. You can specify a single address or an address range.

Gateway: The IP address of the gateway router for the WAP250G, which is used if the requested destination address is not on the local subnet.

DNS IP Address: The IP address of a Domain Name Server on the network. A DNS maps numerical IP addresses to domain names and can be used to identify network hosts by familiar names instead of the IP addresses.

Network Settings - PPPoE Setting

Many Internet service providers (ISPs) use the Point-to-Point Protocol over Ethernet (PPPoE) to automatically assign an IP address to users with a DSL modem. The PPPoE page provides the settings needed for this service (FIG. 35).

FIG. 35 Network Settings - PPPoE Settings

The items on this page include:

PPPoE Setting: Enables the WAP250G IP address to be assigned automatically from an

Internet service provider (ISP) through an ADSL modem using PPPoE.

Username: If your ISP has provided you with a PPPoE user name, enter it in the corresponding text box.

Password: If your ISP has provided you with a PPPoE password, enter it in the corresponding text box.

36 NXA-WAP250G 802.11b/g Wireless Access Point