AMX NXA-WAP250G manual System Configuration

Page 45

System Configuration

Start Upgrade — Starts the download process. Be sure to allow enough time for the download to complete before rebooting the WAP250G.

When you have downloaded the software file, you must reboot the WAP250G to implement the new code.

NXA-WAP250G 802.11b/g Wireless Access Point	41

Image 45

Contents NXA-WAP250G AMX Limited Warranty and Disclaimer Table of Contents Appendix a Troubleshooting Important Note FCC Radiation Exposure Statement Federal Communication Commission Interference StatementEC Conformance Declaration Overview SpecificationsPower Connector Reset ButtonEthernet Port Installation Access Point Configuration Straight-Through WiringTwisted-Pair Cable Assignments Reset Button Overview Ethernet LAN Port Antenna Power Socket CAT5 WallMount SlotsLED Indicators Hardware DescriptionSymptom Action Power LED is Off Diagnosing Access Point IndicatorsAccess Point Mode Selecting an Operation ModeAccess Point Mode roaming for mobile users Access Point Mode RoamingBridge Mode Access Point Mode Repeater and Bridge ModeLogging into the Web Interface LoginOperation Mode Setting Using the Setup WizardSetup Wizard Network Setting Network SettingSetup Wizard Network Setting PPoE settings Wireless VAP #1 Setting Dhcp Server/NAT SettingSetup Wizard Wireless VAP #1 Setting WEP settings Setup Wizard Wireless VAP #2 Setting Wireless VAP #2 SettingSetup Wizard Wizard configuration done Finish and RebootPage System Configuration Network InformationSystem Information Information SystemClient Information Information ClientInformation Event Log Information NetworkSystem Setting Administration System SettingOperation Modes System Setting Vlan Status / Operation ModeSystem Settings Reset System System Setting VAP ManagementWireless VAP Settings Basic Setting Wireless VAP SettingsWireless VAP 1 Setting Basic Settings Wireless VAP Settings Channel SettingAuthentication Mode Select Open or Shared Wireless VAP Settings WEP SettingSystem Configuration WPA, WPA2, WPA-WPA2 Mix Mode Wireless VAP Settings WPA / WPA2 SettingNetwork Settings Dhcp Client Setting Network SettingsNetwork Settings Dhcp Server/NAT Settings Network Settings Dhcp Server/NAT SettingNetwork Settings PPPoE Settings Network Settings PPPoE SettingNetwork Settings Radius Server Settings Network Settings Radius Server SettingTime and Log Time SettingUpdating Firmware Upgrade via the WebFirmware Upgrade Local File Upgrade via a Remote ServerSystem Configuration Page If Your WAP250G Is Stuck on the Emergent Recovery Screen Choose Download site and Install Tftp ServerWebsite for free Tftp Server Copy Firmware file Change Tftp Server SettingsEthernet Connectivity Launch Tftp ServerRe-Connect to WAP 250G Tftp Server Configuration dialogPage Glossary NXA-WAP250G 802.11b/g Wireless Access Point It’s Your World Take Control