Initial Configuration
Using the Setup Wizard
There are only a few basic steps you need to set up the
The Setup Wizard takes you through configuration procedures for the general network settings, such as IP configuration, wireless network name (Service Set Identifier), and wireless security. Follow these steps:
To begin, login and select Start with Setup Wizard on the home page (FIG. 5).
Step 1: Operation Mode Setting
Select an operation mode according to how the unit will be used in your network (FIG. 6).
FIG. 6 Setup Wizard - Operation Mode setting
There are two operation modes:
AP — Set the device as an Access Point. The device can also act as a root bridge in a wireless bridge network.
Repeater & Bridge — Set the device as a Wireless Repeater. The Root AP MAC Address can be assigned manually or selected after clicking Scan.
Reboot the
Click Next to proceed.
13 | |
|
|