AMX NXA-WAP250G manual EC Conformance Declaration

Page 6

Compliances

EC Conformance Declaration

Marking by the above symbol indicates compliance with the Essential Requirements of the R&TTE Directive of the European Union (1999/5/EC). This equipment meets the following conformance standards:

EN 60950-1 (IEC 60950-1) - Product Safety

EN 300 328 - Technical requirements for 2.4 GHz radio equipment

EN 301 489-1, EN 301 489-17 - EMC requirements for radio equipment

This device is intended for use in the following European Community countries:

• Austria	• Belgium	• Denmark
• Finland	• France	• Germany
• Italy	• Luxembourg	• Netherlands
• Norway	• Spain	• Sweden
• Switzerland	• United Kingdom	• Portugal
• Greece	• Ireland	• Iceland

Requirements for indoor vs. outdoor operation, license requirements and allowed channels of operation apply in some countries as described below:

In Italy the end-user must apply for a license from the national spectrum authority to operate this device outdoors.

In Belgium outdoor operation is only permitted using the 2.46 - 2.4835 GHz band: Channel 13.

In France outdoor operation is only permitted using the 2.4 - 2.454 GHz band: Channels 1 - 7.

2	NXA-WAP250G 802.11b/g Wireless Access Point

Image 6

Contents NXA-WAP250G AMX Limited Warranty and Disclaimer Table of Contents Appendix a Troubleshooting Federal Communication Commission Interference Statement Important Note FCC Radiation Exposure StatementEC Conformance Declaration Specifications OverviewPower Connector Reset ButtonEthernet Port Installation Access Point Configuration Straight-Through WiringTwisted-Pair Cable Assignments LED Indicators Ethernet LAN Port Antenna Power Socket CAT5 WallMount SlotsReset Button Overview Hardware DescriptionDiagnosing Access Point Indicators Symptom Action Power LED is OffSelecting an Operation Mode Access Point ModeAccess Point Mode Roaming Access Point Mode roaming for mobile usersAccess Point Mode Repeater and Bridge Mode Bridge ModeLogin Logging into the Web InterfaceUsing the Setup Wizard Operation Mode SettingNetwork Setting Setup Wizard Network SettingSetup Wizard Network Setting PPoE settings Dhcp Server/NAT Setting Wireless VAP #1 SettingSetup Wizard Wireless VAP #1 Setting WEP settings Wireless VAP #2 Setting Setup Wizard Wireless VAP #2 SettingFinish and Reboot Setup Wizard Wizard configuration donePage System Configuration Information NetworkInformation System System InformationInformation Client Client InformationInformation Network Information Event LogSystem Setting System Setting AdministrationSystem Setting Vlan Status / Operation Mode Operation ModesSystem Setting VAP Management System Settings Reset SystemWireless VAP Settings Wireless VAP Settings Basic SettingWireless VAP Settings Channel Setting Wireless VAP 1 Setting Basic SettingsWireless VAP Settings WEP Setting Authentication Mode Select Open or SharedSystem Configuration Wireless VAP Settings WPA / WPA2 Setting WPA, WPA2, WPA-WPA2 Mix ModeNetwork Settings Network Settings Dhcp Client SettingNetwork Settings Dhcp Server/NAT Setting Network Settings Dhcp Server/NAT SettingsNetwork Settings PPPoE Setting Network Settings PPPoE SettingsNetwork Settings Radius Server Setting Network Settings Radius Server SettingsTime Setting Time and LogUpgrade via the Web Updating FirmwareUpgrade via a Remote Server Firmware Upgrade Local FileSystem Configuration Page If Your WAP250G Is Stuck on the Emergent Recovery Screen Choose Download site and Install Tftp ServerWebsite for free Tftp Server Ethernet Connectivity Change Tftp Server SettingsCopy Firmware file Launch Tftp ServerTftp Server Configuration dialog Re-Connect to WAP 250GPage Glossary NXA-WAP250G 802.11b/g Wireless Access Point It’s Your World Take Control