AMX NXA-WAP250G manual Access Point Mode Roaming, Access Point Mode roaming for mobile users

Page 14

Initial Configuration

Access Point Mode - Roaming

A wireless network can also support roaming for mobile users (FIG. 2). Multiple NXA-WAP250Gs can be placed so that a continuous coverage area is created. Wireless users within this area can move freely and remain connected to the network. All NXA-WAP250Gs and wireless stations in the network must be configured with the same SSID. Neighboring NXA-WAP250Gs should be set to non-interfering radio channels (that is, channels 1, 6, or 11 for 802.11b/g).

Video display monitor

NetLinx Central Controller

NXA-ENET24 Switch

A/V Rack

NXA-ENET24 Switch

NXA-WAP250G

NXA-WAP250G

MVP Wireless

<BSS2>

Touch Panel

 

 

 

<BSS1>

FIG. 2 Access Point Mode - roaming for mobile users

<ESS>

10

NXA-WAP250G 802.11b/g Wireless Access Point

Image 14
Contents NXA-WAP250G AMX Limited Warranty and Disclaimer Table of Contents Appendix a Troubleshooting Federal Communication Commission Interference Statement Important Note FCC Radiation Exposure StatementEC Conformance Declaration Specifications OverviewEthernet Port Power ConnectorReset Button Installation Twisted-Pair Cable Assignments Access Point ConfigurationStraight-Through Wiring LED Indicators Ethernet LAN Port Antenna Power Socket CAT5 WallMount SlotsReset Button Overview Hardware DescriptionDiagnosing Access Point Indicators Symptom Action Power LED is OffSelecting an Operation Mode Access Point ModeAccess Point Mode Roaming Access Point Mode roaming for mobile usersAccess Point Mode Repeater and Bridge Mode Bridge ModeLogin Logging into the Web InterfaceUsing the Setup Wizard Operation Mode SettingNetwork Setting Setup Wizard Network SettingSetup Wizard Network Setting PPoE settings Dhcp Server/NAT Setting Wireless VAP #1 SettingSetup Wizard Wireless VAP #1 Setting WEP settings Wireless VAP #2 Setting Setup Wizard Wireless VAP #2 SettingFinish and Reboot Setup Wizard Wizard configuration donePage System Configuration Information NetworkInformation System System InformationInformation Client Client InformationInformation Network Information Event LogSystem Setting System Setting AdministrationSystem Setting Vlan Status / Operation Mode Operation ModesSystem Setting VAP Management System Settings Reset SystemWireless VAP Settings Wireless VAP Settings Basic SettingWireless VAP Settings Channel Setting Wireless VAP 1 Setting Basic SettingsWireless VAP Settings WEP Setting Authentication Mode Select Open or SharedSystem Configuration Wireless VAP Settings WPA / WPA2 Setting WPA, WPA2, WPA-WPA2 Mix ModeNetwork Settings Network Settings Dhcp Client SettingNetwork Settings Dhcp Server/NAT Setting Network Settings Dhcp Server/NAT SettingsNetwork Settings PPPoE Setting Network Settings PPPoE SettingsNetwork Settings Radius Server Setting Network Settings Radius Server SettingsTime Setting Time and LogUpgrade via the Web Updating FirmwareUpgrade via a Remote Server Firmware Upgrade Local FileSystem Configuration Page Website for free Tftp Server If Your WAP250G Is Stuck on the Emergent Recovery ScreenChoose Download site and Install Tftp Server Ethernet Connectivity Change Tftp Server SettingsCopy Firmware file Launch Tftp ServerTftp Server Configuration dialog Re-Connect to WAP 250GPage Glossary NXA-WAP250G 802.11b/g Wireless Access Point It’s Your World Take Control