AMX NXA-WAP250G manual Information, Network

Page 26

System Configuration

Configuration Options (Cont.)

Menu	Description	Page

Wireless VAP 1, 2 (Wireless VAP 2 is only available when the Operation Mode is set to AP)

Basic	Enables the VAP interface and sets the SSID	29

Channel	Sets the radio channel	30

WEP	Configures WEP security	31

WPA-PSK	Configures WPA-PSK security	33

Network

DHCP Client	Enables DHCP client or manually sets an IP address	34

DHCP Server/NAT	Enables DHCP server and configures NAT settings	35

PPPoE	Configures PPPoE settings	36

Time & Log

SNTP	Sets the system clock using SNTP	38

Update

Upgrade via the Web Page	Upgrades system software from a local file	39

Upgrade via a Remote Server	Upgrades system software from a file on an FTP or TFTP server	40

Information

The Information pages display details on the current configuration and status of the WAP250G, including associated wireless stations and event log messages (FIG. 17).

FIG. 17 Information page

The items on the Information pages page are for status display only, and are not configurable.

22	NXA-WAP250G 802.11b/g Wireless Access Point

Image 26

Contents NXA-WAP250G AMX Limited Warranty and Disclaimer Table of Contents Appendix a Troubleshooting Federal Communication Commission Interference Statement Important Note FCC Radiation Exposure StatementEC Conformance Declaration Specifications OverviewEthernet Port Power ConnectorReset Button Installation Twisted-Pair Cable Assignments Access Point ConfigurationStraight-Through Wiring LED Indicators Ethernet LAN Port Antenna Power Socket CAT5 WallMount SlotsReset Button Overview Hardware DescriptionDiagnosing Access Point Indicators Symptom Action Power LED is OffSelecting an Operation Mode Access Point ModeAccess Point Mode Roaming Access Point Mode roaming for mobile usersAccess Point Mode Repeater and Bridge Mode Bridge ModeLogin Logging into the Web InterfaceUsing the Setup Wizard Operation Mode SettingNetwork Setting Setup Wizard Network SettingSetup Wizard Network Setting PPoE settings Dhcp Server/NAT Setting Wireless VAP #1 SettingSetup Wizard Wireless VAP #1 Setting WEP settings Wireless VAP #2 Setting Setup Wizard Wireless VAP #2 SettingFinish and Reboot Setup Wizard Wizard configuration donePage System Configuration Information NetworkInformation System System InformationInformation Client Client InformationInformation Network Information Event LogSystem Setting System Setting AdministrationSystem Setting Vlan Status / Operation Mode Operation ModesSystem Setting VAP Management System Settings Reset SystemWireless VAP Settings Wireless VAP Settings Basic SettingWireless VAP Settings Channel Setting Wireless VAP 1 Setting Basic SettingsWireless VAP Settings WEP Setting Authentication Mode Select Open or SharedSystem Configuration Wireless VAP Settings WPA / WPA2 Setting WPA, WPA2, WPA-WPA2 Mix ModeNetwork Settings Network Settings Dhcp Client SettingNetwork Settings Dhcp Server/NAT Setting Network Settings Dhcp Server/NAT SettingsNetwork Settings PPPoE Setting Network Settings PPPoE SettingsNetwork Settings Radius Server Setting Network Settings Radius Server SettingsTime Setting Time and LogUpgrade via the Web Updating FirmwareUpgrade via a Remote Server Firmware Upgrade Local FileSystem Configuration Page Website for free Tftp Server If Your WAP250G Is Stuck on the Emergent Recovery ScreenChoose Download site and Install Tftp Server Ethernet Connectivity Change Tftp Server SettingsCopy Firmware file Launch Tftp ServerTftp Server Configuration dialog Re-Connect to WAP 250GPage Glossary NXA-WAP250G 802.11b/g Wireless Access Point It’s Your World Take Control