Allied Telesis AT-SBX3165, X3112, AT-SBX31FAN manual Installing the AT-SBx31CFC Fabric Control Card

Chapter 2: Installation

Installing the AT-SBx31CFC Fabric Control Card

Perform the following procedure to install the AT-SBx31CFC Card:

Caution

The AT-SBx31CFC Card contains active electronic devices, which can be damaged by electro-static discharges (ESD). Follow the procedure given in “Protection Against Electrostatic Discharge (ESD)” on page 60 to guard against ESD damage when unpacking and installing this card.

1.Choose a slot in the chassis for the AT-SBx31CFC Fabric Control Card. It can be installed in either slot 4 or 5.

2.Remove all components from the shipping package.

Note

Store the packaging material in a safe location. You may use the original shipping material if you need to return the unit to Allied Telesis.

3.Ensure that the following components are included in your package.

–One AT-SBx31CFC Management Fabric Card

–One RJ45 to DB9 management cable

If either item is missing or damaged, contact your Allied Telesis sales representative for assistance.

4.Move the locking handles on the front panel to the open position as shown in Figure 40.

SBx31		CFC
SYS	STATUS			SBx
M/S
	SLMASTER			0STATUS
PSU	AVE			2	1
	NORMAL				3
	FAULT			4
FAN	NORMAL		M/S		5	CFC	1000 LINK
	FAULT	RESET	PSU	6	7				ACT
				8			10/100	LINK
			FAN		9				ACT
				10			NET MGMT
			SD		11
		READY	BUSY						CONSOLE
				FAULT			L/A
							10/100/1000Base-T
									RS-232
									1822

Figure 40. Opening the Locking Handles of the AT-SBx31CFC Fabric

Control Card

68