SwitchBlade x3112 Installation Guide
The AT-SBx31CFC Fabric Control Card supports the following features:
Supports up to 40 ports at 10 Gbps of full-duplex data exchange or 400 Gbps switching throughput capacity with two AT-SBx31CFC Fabric Control Cards installed.
Supports a non-redundant switching configuration with one AT- SBx31CFC Fabric Control Card installed. This configuration is non- blocking if the Ethernet traffic on each line card does not exceed a line rate of 20 Gbps.
Supports a redundant, non-blocking switching configuration with two AT-SBx31CFC Fabric Control Cards installed.
Centralized LED for status of all line cards installed in the AT-SBx3112 Chassis.
Supports an eco-friendly button for enabling/disabling port and status LEDs on all line cards.
Provides a system reset switch.
Supports an SD Card slot for data storage and retrieval.
Provides a USB port for data storage and retrieval on a USB device.
Supports a remote management via a 10/100/1000 Base-T network management port.
Supports local management via an RS-232 CONSOLE port.
Front loading access is provided for servicing.
Supports a hot swappable design for all modules.
The AT-SBx31CFC Fabric Control Card has two types of status LEDs on the front panel:
“System Status LEDs” , next
“SBx STATUS LEDs” on page 23
System Status LEDs
The System Status LEDs on the AT-SBx31CFC Fabric Control Card display general status information about the management system status, the power supplies, and the Fan Tray. These LEDs are displayed in Figure 5 and described in Table 3 on page 22.
M/S
PSU
FAN
1816
Figure 5 System Status LEDs
