Omnitron Systems Technology 2FXM2 user manual Led

From the Chassis View menu, select the desired module (select 1 or 5), press <ENTER>. The Module configuration screen will be displayed.

PI

Module - iConverter 2FXM2			iConverter, Serial Agent
Identifier -
Chassis Number	= 1		Switch ON condition	OFF condition		H/W	Actual
Slot Number	=	11	1: Pause Enabled	Pause Disabled		Off	Off
Model Number	=	8959N-0	2: Port 1 HDX	Port 1 FDX		Off	Off
			3: Not Available
Serial Number	= xxxxxxxx		4: Not Available
Manufacturing Date = xxxxxxxx			5: Port 2 HDX	Port 2 FDX		Off	Off
Product Revision	= xx		6: Link Propagate	Link Segment		Off	Off
Software Revision	= xx		7: Remote Fault	Normal		Off	Off
			8: Symm Fault Det	Normal		Off	Off
LED			9: BP A Enabled	BP A Disabled		Off	Off
1: Power	= On		10: BP B Enabled	BP B Disabled		Off	Off
2: Power Supply 1	= Off		11: Not Available
3: Power Supply 2	= Off		12: Slave Only	Master/Slave		Off	Off
4: Power Supply 3	= Off		13: Not Available
5: Port 1 Link	= Off		14: Not Available
6: Port 1 FDX	= Off		15: Not Available
7: BP Master	= Off		16: Not Available
8: Port 2 Link	= Off		OAM settings:
9: Port 2 FDX	= Off		17: IP protocol State		On
			18: Management Mode		Secure OAM
Toggle Switch(1-16), (I)dentifier, (R)eset, (H)elp, (P)ortStat, Port(C)tl >

The Module configuration screen provides general information concerning the configuration and status of the module. The screen displays the model and serial numbers, hardware and software revisions, as well as the condition of the LEDs and DIP-switches. The DIP-switches can be re-configured (options 1 -10, 12) without removing the module from the chassis. Select the appropriate option to change the DIP-switch setting. Selecting DIP-switch options 1 - 10 and 12, will cause the selection to change states under the ‘Actual’ heading.

NOTE: The Plug-In Module configuration screen is shown. The standalone Module configuration screen will display LED 2, 3, 4, and 7 and DIP-switches 9, 10 and 12 as NOT AVAILABLE.

Page 24