
MultiModemBA User Guide
S9
Carrier Detect Response Time
Unit: | 100 mSec. |
Range: | |
Default: | 6 |
Description: | S9 sets the time delay between when the modem first detects a valid incoming |
| carrier signal and when the modem turns on its Carrier Detect circuit. The default |
| setting is 600 milliseconds, or six units of 100 mSec each (Decimal 6). S9 may be set |
| for up to 25.5 seconds. |
S10
Carrier Loss Disconnect Delay Time
Unit: | 100 mSec. |
Range: | |
Default: | 7 |
Description: | S10 sets the time a carrier signal must be lost before the modem disconnects. The |
| default setting is 700 mSec, or seven units (Decimal 7) of 100 mSec. Maximum delay |
| is 25.4 seconds (Decimal 254). Setting the S10 value to 255 causes the modem to |
| not disconnect with loss of carrier. (This |
| and less.) |
S11
Tone Dialing: Tone Spacing and Duration
Unit: | 1 mSec. |
Range: | |
Default: | 70, 80* |
Description: | S11 sets the speed of tone dialing (spacing and tone duration times). The default |
| value is 70 units (Decimal 7) or 80 units, where each unit is one mSec, meaning that |
| each tone is on for 70 mSec with a 70 mSec pause between each. |
| The minimum S11 value allowed by most telephone systems is 50 mSec (50 units). |
| Very few telephone systems can handle anything faster than that. The maximum S11 |
| value is 255 mSec (255 units). |
S13
Remote Configuration Escape Character
Unit: | ASCII Character |
Range: | |
Default: | 37 (%) |
Description: | S13 defines the remote configuration escape character (which becomes your |
| modem’s remote configuration character). The default is three percent symbols |
| (%%%). When the S13 character is entered three consecutive times from a remotely |
| connected site, your modem responds with its Remote Configuration procedure. |
*Value for International and DOC units
**Value for International units only
52