Multi-Tech Systems MT4X56USB manual

Index

For Windows 95	19
For Windows 98	16
For Windows NT 4.0	21
Local analog loopback test	61
Local digital loopback test	63
Loopback tests	60
Local Analog (V.54 Loop 3)	61
Local digital (V.54 loop 2)	63
Remote digital (V.54 loop 2)	62
M
Manufacturer/model information	75
Messages	51
ML-PPP bonding	6
MNP 5 data compression	47
MNP error correction	46
Modem installation	27
Modem Port Flow Control command	45
Modem ports, LED status	9
Modem Reset command	43
Modulation Handshake command	42
MT4X56USB
Back panel	10
Cabling	13
Drivers for Windows 2000	23
Drivers for Windows 95	19
Drivers for Windows 98	16
Drivers for Windows NT 4.0	21
Features	6
Front panel	9
Introduction	6
Modem installation	27, 31
Service	72
System USB support	16
Technical specifications	7
Technical support	71
Testing	58
Troubleshooting	58
Unpacking	12
Upgrading firmware	66
Multi-Tech Web site	66
N
New Zealand Telecom Warning Notice	77
O
On-hook/off-hook	41
On-line Warranty Registration	71
Online command mode	40
P
Pause time for comma, setting	49
Power Connector	10
Power LED	58
Protocol Result Code command	47

Pulse Dialing command		42
R
Rate, maximum data		49
Read Register Value command		42
Recording MT4X56USB information		71
Registration Number (FCC)		75
Regulatory information		74
Remote configuration
Changing the escape character		55
Commands		55
Procedure		54
Setup		54
Remote digital loopback test		62
Repeat command		40
Resetting the modem		43
Result Code Format command		43
Result Code Options command		43
Result Code Selection command		43
Result codes	40, 47, 51, 59
Result Codes Enable/Disable command		............... 42
Return Online to Data Mode command		42
Rings, setting number of		49
RJ11 modem connector		10
ROM checksum		42
S
S-registers		49
reading		42
S0		49
S1		49
S10		49
S108		50
S109		50
S11		49
S2		49
S28		49
S3		49
S30		49
S35		49
S36		49
S37		49
S38		50
S4		49
S42		50
S43		50
S48		50
S5		49
S6		49
S7		49
S8		49
S89		50
S9		49, 55
setting		42
Safety warning		12

MT4X56USB 95