MicroNet Technology SP5054, SP5050, SP5052 user manual Adjust Input Tone Level

Page 17

620/480, take the following procedures.

620/479

620/480

620/481

621/479

621/480

621/481

619/479

619/480

619/481

If the line port of gateway was locked, please use “hangup 0” command to release LINE 1, “hanhup 1” to release LINE 2…etc.

4.4 Adjust Input Tone Level

Sometimes the disconnect tone level is too low to be detected by VoIP FXO gateway. You can increase input gain from the following command.

voice -volume input xx commit

reboot

xxis the input gain parameters. The maximum number is 35. if the number is over 35, the echo may be happened. Once you increase input gain, the voice volume from PSTN to IP side is increased too.

17

Image 17
Contents User’s Manual Introduction General Features Features and specificationAudio feature IntroductionBack panel Management FeaturesAppearance GND Pin Name Dir DescriptionStart System Operating ProcedureHyper Terminal Setting IP Environment SettingSystem Requirement Telephone Line RequirementPage Page Gatekeeper Mode Initializing VoIP FXO Gateway SettingConfigure VoIP FXO gateway Password Usr/config$ ifaddr -ip 10.1.1.1 -mask 255.2555.255.0 -gate Peer-to-Peer ModeUsr/config$ h323 -mode 0 -gk 10.2.2.2 -e164 -alias fxo Usr/config$ h323 -modeBehind IP-Sharing Usr/config$ pbook -add name TEST1 ip 10.1.1.1 e164Fixed IP Address usr/config$ ifaddr -ipsharing 1 Dynamic IP Address -usr/config$ ifaddr -ipsharing How to configure disconnect tone on VoIP FXO gateway Disconnect Tone ConfigurationWhat is Disconnect Tone There are two ways to analyze the disconnect tone Adjust Tone Table parameters manuallyExamples how to configure Tone table Adjust Input Tone Level Help command Command listsQuit command Debug commandUsr/config$ debug -add h323 vp usr/config$ debug -open Reboot commandFlash command Ifaddr command Commit commandPing command Time commandUsr/config$ ifaddr -sntp 1 Usr/config$ time Current time is THU JAN 01 052923Greetrd command Exit exit this command Parameter Usages Pbook commandAutomatic sequence number as index Phonebook RulesPppoe Sysconf command$h323 -mode 1 peer-to-peer mode LineToLine feature should be used together with$sysconf -2nddial 1 2nddial on $bureau Print$bureau 192.168.4.184 Please refer to 5.21 bureau commandValue is set to enable all ports Usr/config$ sysconf -sendxcode 1 -access set1 14 h323 commandPage Usr/config$ gk Gatekeeper information and configuration Gk commandVoice command Display voice codec information and configuration Usr/config$ voice -mindelay 90 -maxdelay 150 -optfacor Tos commandUsr/config$ voice -nscng g723 Support command Tone commandGroup command Usr/config$ group -pattern 1 3 -e164 100 Bureau commandPage Rom command Prefix commandPage Passwd command TFTP/FTP server Upgrade the VoIP FXO gatewayDownload Procedure Page Browse the IP Address which has predefined via RS-232 Appendix Web configurationInput the login name and password Network Interface Start configureH323 Information System Config Voice Setting For Advanced User Phone Pattern For Advanced User Page Phone Book For Peer-to-Peer mode only Type Of Service Hot Lines PPPoE Password ROM Upgrade Flash Clean Commit Data Reboot System