MicroNet Technology SP5050, SP5052, SP5054 user manual Passwd command

Page 42

 

asking for pincode.

-s

to specify TFTP server’s IP address when upgrading ROM files.

-f

to specify the target file name, which will replace the old one.

-method

to decide using TFTP or FTP as file transfer server. “0” stands

 

for TFTP, while “1” stands for FTP.

-ftp

if users choose FTP in above item, it is necessary to specify

 

pre-defined username and password when upgrading files.

5.24 [passwd] command

For security concern, users have to input the password before entering configuration mode.

usr/config$ passwd

Password setting information and configuration Usage:

passwd -set Loginname Password Note:

Loginname can be only 'root' or 'administrator' Example:

passwd -set root 2fxo

Parameter Usages:

-passwd <login name> <password>

Note:

<login name> can be “root” or “administrator” only. “root” and “administrator” have the same authorization, except3 commands that can be executed by “root” only – “passwd –set root”, “rom –boot”, and “flash –clean”

42

Image 42
Contents User’s Manual Introduction Audio feature Features and specificationGeneral Features IntroductionManagement Features AppearanceBack panel Pin Name Dir Description GNDSystem Operating Procedure StartSystem Requirement IP Environment SettingHyper Terminal Setting Telephone Line RequirementPage Page Initializing VoIP FXO Gateway Setting Gatekeeper ModeConfigure VoIP FXO gateway Password Usr/config$ h323 -mode 0 -gk 10.2.2.2 -e164 -alias fxo Peer-to-Peer ModeUsr/config$ ifaddr -ip 10.1.1.1 -mask 255.2555.255.0 -gate Usr/config$ h323 -modeUsr/config$ pbook -add name TEST1 ip 10.1.1.1 e164 Fixed IP Address usr/config$ ifaddr -ipsharing 1Behind IP-Sharing Dynamic IP Address -usr/config$ ifaddr -ipsharing Disconnect Tone Configuration What is Disconnect ToneHow to configure disconnect tone on VoIP FXO gateway Adjust Tone Table parameters manually Examples how to configure Tone tableThere are two ways to analyze the disconnect tone Adjust Input Tone Level Quit command Command listsHelp command Debug commandReboot command Flash commandUsr/config$ debug -add h323 vp usr/config$ debug -open Commit command Ifaddr commandUsr/config$ ifaddr -sntp 1 Time commandPing command Usr/config$ time Current time is THU JAN 01 052923Greetrd command Exit exit this command Pbook command Parameter UsagesPhonebook Rules Automatic sequence number as indexSysconf command Pppoe$sysconf -2nddial 1 2nddial on LineToLine feature should be used together with$h323 -mode 1 peer-to-peer mode $bureau PrintPlease refer to 5.21 bureau command $bureau 192.168.4.184Value is set to enable all ports 14 h323 command Usr/config$ sysconf -sendxcode 1 -access set1Page Gk command Usr/config$ gk Gatekeeper information and configurationVoice command Display voice codec information and configuration Tos command Usr/config$ voice -nscng g723Usr/config$ voice -mindelay 90 -maxdelay 150 -optfacor Tone command Support commandGroup command Bureau command Usr/config$ group -pattern 1 3 -e164 100Page Prefix command Rom commandPage Passwd command Upgrade the VoIP FXO gateway Download ProcedureTFTP/FTP server Page Appendix Web configuration Browse the IP Address which has predefined via RS-232Input the login name and password Start configure Network InterfaceH323 Information System Config Voice Setting For Advanced User Phone Pattern For Advanced User Page Phone Book For Peer-to-Peer mode only Type Of Service Hot Lines PPPoE Password ROM Upgrade Flash Clean Commit Data Reboot System