MicroNet Technology SP5050, SP5052, SP5054 user manual Time command, Ping command, Ifaddr -timezone

ifaddr -timezone 8

Parameters Usage:

-print	print current IP setting
-ip	assigned IP address for VoIP FXO gateway
-mask	internet subnet mask
-gate	IP default gateway
-dhcp	Dynamic Host Configuration (1 = ON; 0 = OFF)
-sntp	Simple Network Time Protocol (1 = ON; 0 = OFF) When SNTP
	function is activated, users have to specify a SNTP server as
	network time source. An example is demonstrated below:

usr/config$ ifaddr -sntp 1 10.1.1.1

while 10.1.1.1 stands for SNTP server’s IP address.

-timezone	Set timezone for VoIP FXO gateway. User can set different time
	zone according to the location VoIP FXO gateway. For example,
	in Taiwan the time zone should be set as 8,which means
	GMT+8.
-cmcenter	Set management center IP address. IF user specifies
	management center IP address, VoIP FXO gateway will send
	information to management center, let user can easily configure
	via management center interface. (sysconf –cmcenter “IP
	address of management center”)

Note:

Mmanagement center is optional software to help user can easily configure Micronet products, please contact your reseller to know more about it.

-ipsharing Specify usage of an IP sharing device and IP address. If VoIP FXO gateway is behind a IP-sharing , user can enable IP sharing function and specify public IP address of IP sharing device.

5.8 [time] command

When SNTP function of VoIP FXO gateway is enabled and SNTP server can be found as well, type time command to show current network time.

usr/config$ time

Current time is THU JAN 01 05:29:23 1970

5.9 [ping] command

Use ping to test whether a specific IP is reachable or not. For example: if 192.168.1.2 is not existing while 210.63.15.32 exists. Users will have the following results:

usr/config$ ping 210.54.23.129 PING 210.54.23.129: 56 data bytes

21