MicroNet Technology SP5052, SP5050, SP5054 user manual Appearance, Management Features, Back panel

Page 4

Management Features:

-Console port: RS-232C port

-TELNET

-HTTP Brower (e.g. Internet Explorer)

1.2Appearance

Front panel: The LED light provides system message of Micronet SP5050 Series.

Front panel of SP5050

Power : Light on means Micronet SP5050 Series is power on.

L1-L6 :Light on means the line is in use.

Link : Light on means Micronet SP5050 Series is connected to the network correctly.

Act : LED should be light on and in flash display when data is transmitting.

Ready : 1. Light on and in slow flash means Micronet SP5050 Series is in operation mode.

Status : 1. Light on means Micronet SP5050 Series successfully registered to Gatekeeper when it is set as Gatekeeper Mode.

2.LED flash means Micronet SP5050 Series is not registered to Gatekeeper when it is set as Gatekeeper Mode.

3.Or when Micronet SP5050 Series is in downloading mode, LED should be flash as well.

4.Light off means Micronet SP5050 Series is in Peer-to-Peer Mode.

Back panel:

Back panel of SP5050

10 Base-T:RJ-45 Modular Jack Female connector with 10 Mbps Ethernet.

4

Image 4
Contents User’s Manual Introduction Features and specification General FeaturesAudio feature IntroductionAppearance Management FeaturesBack panel Pin Name Dir Description GNDSystem Operating Procedure StartIP Environment Setting Hyper Terminal SettingSystem Requirement Telephone Line RequirementPage Page Initializing VoIP FXO Gateway Setting Gatekeeper ModeConfigure VoIP FXO gateway Password Peer-to-Peer Mode Usr/config$ ifaddr -ip 10.1.1.1 -mask 255.2555.255.0 -gateUsr/config$ h323 -mode 0 -gk 10.2.2.2 -e164 -alias fxo Usr/config$ h323 -modeFixed IP Address usr/config$ ifaddr -ipsharing 1 Usr/config$ pbook -add name TEST1 ip 10.1.1.1 e164Behind IP-Sharing Dynamic IP Address -usr/config$ ifaddr -ipsharing What is Disconnect Tone Disconnect Tone ConfigurationHow to configure disconnect tone on VoIP FXO gateway Examples how to configure Tone table Adjust Tone Table parameters manuallyThere are two ways to analyze the disconnect tone Adjust Input Tone Level Command lists Help commandQuit command Debug commandFlash command Reboot commandUsr/config$ debug -add h323 vp usr/config$ debug -open Commit command Ifaddr commandTime command Ping commandUsr/config$ ifaddr -sntp 1 Usr/config$ time Current time is THU JAN 01 052923Greetrd command Exit exit this command Pbook command Parameter UsagesPhonebook Rules Automatic sequence number as indexSysconf command PppoeLineToLine feature should be used together with $h323 -mode 1 peer-to-peer mode$sysconf -2nddial 1 2nddial on $bureau PrintPlease refer to 5.21 bureau command $bureau 192.168.4.184Value is set to enable all ports 14 h323 command Usr/config$ sysconf -sendxcode 1 -access set1Page Gk command Usr/config$ gk Gatekeeper information and configurationVoice command Display voice codec information and configuration Usr/config$ voice -nscng g723 Tos commandUsr/config$ voice -mindelay 90 -maxdelay 150 -optfacor Tone command Support commandGroup command Bureau command Usr/config$ group -pattern 1 3 -e164 100Page Prefix command Rom commandPage Passwd command Download Procedure Upgrade the VoIP FXO gatewayTFTP/FTP server Page Appendix Web configuration Browse the IP Address which has predefined via RS-232Input the login name and password Start configure Network InterfaceH323 Information System Config Voice Setting For Advanced User Phone Pattern For Advanced User Page Phone Book For Peer-to-Peer mode only Type Of Service Hot Lines PPPoE Password ROM Upgrade Flash Clean Commit Data Reboot System