MicroNet Technology SP5050, SP5052, SP5054 user manual

Page 39

-table Set Hot line/Line To Line information. (Port range: 1~2) Note:

Hotline feature should be used together with: $sysconf -service 2 (HotLine service) $sysconf -2nddial 0 (2nddial off) $h323 -mode 1 (peer-to-peer mode)

Line To Line feature should be used together with: $sysconf -service 2 (HotLine service/Line To Line ) $sysconf -2nddial 1 (2nddial on)

$h323 -mode 1 (peer-to-peer mode) Example:

bureau -pstn 2011 2012

bureau -table 1 192.168.4.69 628 2 192.168.4.200 9992

Parameter Usages:

- print: display bureau line information and configuration.

usr/config$ bureau -print

Bureau line setting relate information

PSTN number

: 2011 2012 2013 2014 2015 2016

Hold tone generation : On Hot line / Line to Line table

==================================================

Port Destination Address Remote TEL/CHANNEL

--------------------------------------------------------------------------------------------------

1

192.168.4.69

628

2

192.168.4.69

628

==================================================

- pstn

PSTN number (per port basis). This number is used to display

 

as a caller ID when the caller ID is not available. The maximum

 

digit length is 32.

 

- hold

while the terminals support H.450 hold function, the VoIP FXO

 

gateway will play the hold tone to PSTN side.

- table

Set Hot line/LineToLine destination IP and e164 numbers

 

information.

 

Note:

1.HotLine and LineToLine functions are using the same table.

2.In HotLine service, user have to set line No. prepared to dial out; in LineToLine service ,user have to set port No. For example, if user set bureau –table 1 192.168.4.69 628 in hotline service, after user dial in VoIP FXO gateway port 1, VoIP FXO gateway will direct dial to 192.168.4.69 and dial 628 to PSTN side, then Phone 628 will ring. User will hear ring back tone. If user set bureau –table 1 192.168.4.69 1 in LineToLine service, after user dial in VoIP FXO gateway port 1 , VoIP FXO gateway will direct dial to 192.168.4.69 port 1,user will hear dial tone, then user can dial out No. to PSTN side.

39

Image 39
Contents User’s Manual Introduction Introduction Features and specificationGeneral Features Audio featureManagement Features AppearanceBack panel GND Pin Name Dir DescriptionStart System Operating ProcedureTelephone Line Requirement IP Environment SettingHyper Terminal Setting System RequirementPage Page Gatekeeper Mode Initializing VoIP FXO Gateway SettingConfigure VoIP FXO gateway Password Usr/config$ h323 -mode Peer-to-Peer ModeUsr/config$ ifaddr -ip 10.1.1.1 -mask 255.2555.255.0 -gate Usr/config$ h323 -mode 0 -gk 10.2.2.2 -e164 -alias fxoUsr/config$ pbook -add name TEST1 ip 10.1.1.1 e164 Fixed IP Address usr/config$ ifaddr -ipsharing 1Behind IP-Sharing Dynamic IP Address -usr/config$ ifaddr -ipsharing Disconnect Tone Configuration What is Disconnect ToneHow to configure disconnect tone on VoIP FXO gateway Adjust Tone Table parameters manually Examples how to configure Tone tableThere are two ways to analyze the disconnect tone Adjust Input Tone Level Debug command Command listsHelp command Quit commandReboot command Flash commandUsr/config$ debug -add h323 vp usr/config$ debug -open Ifaddr command Commit commandUsr/config$ time Current time is THU JAN 01 052923 Time commandPing command Usr/config$ ifaddr -sntp 1Greetrd command Exit exit this command Parameter Usages Pbook commandAutomatic sequence number as index Phonebook RulesPppoe Sysconf command$bureau Print LineToLine feature should be used together with$h323 -mode 1 peer-to-peer mode $sysconf -2nddial 1 2nddial on$bureau 192.168.4.184 Please refer to 5.21 bureau commandValue is set to enable all ports Usr/config$ sysconf -sendxcode 1 -access set1 14 h323 commandPage Usr/config$ gk Gatekeeper information and configuration Gk commandVoice command Display voice codec information and configuration Tos command Usr/config$ voice -nscng g723Usr/config$ voice -mindelay 90 -maxdelay 150 -optfacor Support command Tone commandGroup command Usr/config$ group -pattern 1 3 -e164 100 Bureau commandPage Rom command Prefix commandPage Passwd command Upgrade the VoIP FXO gateway Download ProcedureTFTP/FTP server Page Browse the IP Address which has predefined via RS-232 Appendix Web configurationInput the login name and password Network Interface Start configureH323 Information System Config Voice Setting For Advanced User Phone Pattern For Advanced User Page Phone Book For Peer-to-Peer mode only Type Of Service Hot Lines PPPoE Password ROM Upgrade Flash Clean Commit Data Reboot System