MicroNet Technology SP5052, SP5050, SP5054 user manual Group command

-t38	T.38(FAX) enabled/disabled.
-fstart	Fast start enabled/disabled.
-tunnel	H245 Tunneling enabled/disabled.
-h245fs H245 separate channel after faststart.
Example:
support	-fstart 1
support	-tunnel 0
support	-h245fs 1
Parameter Usages:
-print	print current setting in support command.
-t38	to switch ON/OFF (1 = ON; 0 = OFF) T.38 function.T.38 function
	is for FAX. If user will use FAX machines, please switch on T.38
	function.
-fstart	to switch ON/OFF (1 = ON; 0 = OFF) FastStart function. Fast
	Start function can shorten the connection time if the opposite
	party also support FastStart.
-tunnel	to switch ON/OFF (1 = ON; 0 = OFF) H.245 tunneling function.
	If the function is ON, VoIP FXO gateway will send H.245 (Call
	Control messages) via H.225’s (Call Signal messages) link. The
	function is effective only when both side support h245 tunnel.
-h245fs	to set if open H.245 separate channel after fast start or not. (1 =
	ON; 0 = OFF)

Note:

1.it is not recommended to change the value in this command, only if users do know well the application. This might cause incompatibility with other devices.

2.If user wants to use T.38 fax under fast start mode, please make sure “h245fs” function is enabled, or fax can’t work normally.

5.20[group] command

This command is for grouping ports of VoIP FXO gateway. If users need to register at least 2 numbers separately to gatekeeper, then this command is needed for such an application.

usr/config$ group

PSTN side grouping information and configuration Usage:

group -print -enable -disable

-number group_number -pattern pattern_numbers -e164 e164_numbers

-pattern pattern_numbers -e164 e164_numbers -e164 e164_numbers

Comment:
-print	Print current group configuration

37