MicroNet Technology SP5050, SP5052, SP5054 user manual Tone command, Support command

-rtptype	configure TOS type of RTP packets from 0 to 7
-rtcptype	configure TOS type of RTCP packets from 0 to 7
-sigdelay	configure signaling packets as normal delay or low delay
-rtpdelay	configure RTP packets as normal delay or low delay
-rtcpdelay	configure RTCP packets as normal delay or low delay
-sigthruput	configure signaling packets as normal throughput or high
	throughput
-rtpthruput	configure RTP packets as normal throughput or high throughput
-rtcpthruput	configure RTCP packets as normal throughput or high
	throughput
-sigreliab	configure signaling packets as normal reliability or high reliability
-rtpreliab	configure RTP packets as normal reliability or high reliability
-rtcpreliab	configure RTCP packets as normal reliability or high reliability

Note:

Users should be aware that TOS is effective only when network devices (for ex: router, switch.. etc.) support TOS.

5.18 [tone] command

Tone of VoIP FXO gateway is configurable if the bureau line is connected to PABX or PSTN. Users can refer to “greetrd” command for tone recording and analysis. Sometimes the frequencies might shift from standard level. In such a situation, users have to adjust the tone value manually using this command.

usr/config$ tone

Setup of call progress tones Usage:

tone -toneX LowFreq HighFreq LowFreqLevel HighFreqLevel TOn1 TOff1 TOn2 TOff2

tone -print Note:

toneX has the following possibility:

busy1 busy2 reorder1 reorder2 ringtone1 ringtone2 dialtone Example:

tone -busy1 400 0 8 0 50 50 0 0 tone -dialtone 400 0 19 0 25 25 0 0

5.19 [support] command

This command provides some extra functions that might be needed by users.

usr/config$ support

Special Voice function support manipulation Usage:

support[-tunnel enable] support -print

36