MicroNet Technology SP5052, SP5050, SP5054 Phonebook Rules, Automatic sequence number as index

Page 25

 

phone number.

 

Note: <index number> means the sequence number in phone

 

book. If users do not request a specific index number in

 

phone book, VoIP FXO gateway will give each record a

 

automatic sequence number as index.

-add

add a new record to phone book. When adding a record, users

 

have to specify name, ip, and e164 number to complete the

 

command.

-search

search a record in phone book. The searching criteria can be

 

name, ip, or e164.

-delete

delete a specific record. “pbook –delete 3” means delete index

 

3 record.

-insert

add a new record and force to assign a specific index number

 

for it.

-modify

modify an existing record. When using this command, users

 

have to specify the record’s index number, and then make the

 

change.

Phonebook Rules:

To meet the requirements of communicating with trunk gateway or other applications, Phonebook has following characteristics to be noticed.

When the destination side is a terminal, for ex: IP Phone or soft phone, e164 number stands for exact destination phone number.

When the destination side is a gateway, for ex: T1/E1 gateway, e164 phone number stands only for gateway prefix. That is, users have to continue to dial destination number, following the prefix number. An example is as below: A is a VoIP FXO gateway and B is a E1 Trunk gateway, which is connected to PSTN with E1 PRI. There’s a record in A’s phone book

Index

Name

IP

E164

 

 

 

 

 

 

 

 

1

B_gateway

192.168.1.2

0

-------------------------------------------------------------------------------------------

If users want to make a call to PSTN number “82265699”, they have to make a call to connect to VoIP FXO gateway A, and then dial “082265699”. After receiving the complete dialed number, VoIP FXO gateway A will search for its Phone Book, find “0” as matched prefix, and then dial out to B’s IP address directly with destination e.164 (phone number) “82265699”. Pleased be noted that “0” is eliminated from VoIP FXO gateway itself.

Note:

Because of above characteristics, users have to take care of the number plan very well to avoid the numbering conflict. If users already defined “0” for specific trunk gateway, other terminal started with “0” shall be avoided, or the number will be routed to the trunk gateway defined “0”.

25

Image 25
Contents User’s Manual Introduction General Features Features and specificationAudio feature IntroductionAppearance Management FeaturesBack panel GND Pin Name Dir DescriptionStart System Operating ProcedureHyper Terminal Setting IP Environment SettingSystem Requirement Telephone Line RequirementPage Page Gatekeeper Mode Initializing VoIP FXO Gateway SettingConfigure VoIP FXO gateway Password Usr/config$ ifaddr -ip 10.1.1.1 -mask 255.2555.255.0 -gate Peer-to-Peer ModeUsr/config$ h323 -mode 0 -gk 10.2.2.2 -e164 -alias fxo Usr/config$ h323 -modeFixed IP Address usr/config$ ifaddr -ipsharing 1 Usr/config$ pbook -add name TEST1 ip 10.1.1.1 e164Behind IP-Sharing Dynamic IP Address -usr/config$ ifaddr -ipsharing What is Disconnect Tone Disconnect Tone ConfigurationHow to configure disconnect tone on VoIP FXO gateway Examples how to configure Tone table Adjust Tone Table parameters manuallyThere are two ways to analyze the disconnect tone Adjust Input Tone Level Help command Command listsQuit command Debug commandFlash command Reboot commandUsr/config$ debug -add h323 vp usr/config$ debug -open Ifaddr command Commit commandPing command Time commandUsr/config$ ifaddr -sntp 1 Usr/config$ time Current time is THU JAN 01 052923Greetrd command Exit exit this command Parameter Usages Pbook commandAutomatic sequence number as index Phonebook RulesPppoe Sysconf command$h323 -mode 1 peer-to-peer mode LineToLine feature should be used together with$sysconf -2nddial 1 2nddial on $bureau Print$bureau 192.168.4.184 Please refer to 5.21 bureau commandValue is set to enable all ports Usr/config$ sysconf -sendxcode 1 -access set1 14 h323 commandPage Usr/config$ gk Gatekeeper information and configuration Gk commandVoice command Display voice codec information and configuration Usr/config$ voice -nscng g723 Tos commandUsr/config$ voice -mindelay 90 -maxdelay 150 -optfacor Support command Tone commandGroup command Usr/config$ group -pattern 1 3 -e164 100 Bureau commandPage Rom command Prefix commandPage Passwd command Download Procedure Upgrade the VoIP FXO gatewayTFTP/FTP server Page Browse the IP Address which has predefined via RS-232 Appendix Web configurationInput the login name and password Network Interface Start configureH323 Information System Config Voice Setting For Advanced User Phone Pattern For Advanced User Page Phone Book For Peer-to-Peer mode only Type Of Service Hot Lines PPPoE Password ROM Upgrade Flash Clean Commit Data Reboot System