MicroNet Technology SP5054 Gk command, Usr/config$ gk Gatekeeper information and configuration

Page 32

-e164

e164 number, which is registered as phone number in

 

gatekeeper.

-alias

h323 ID, a identification in h323 world for other parties’

 

recognition. The field might be used as a key of authorization or

 

accounting in some VoIP application. It is recommended to assign

 

a special name, or it might conflict with other devices.

-gkdis

Switch ON or OFF of gatekeeper discovery function (1 = ON; 0 =

 

OFF). When it’s ON, VoIP FXO gateway will send GRQ with GK

 

ID to default gatekeeper. If the GK ID didn’t matched, GW will

 

send GRQ with GK ID in multicast.

-rtp

to allocate RTP port range—NOT RECOMMENDED. This may be

 

used when RTP port range conflicts with firewall policy.

-h245

to assign h.245 port number, NOT AVAILABLE for the moment.

-ttl

to set timer for TTL(Time To Live). VoIP FXO gateway would send

 

RRQ, with keepAlive, to gatekeeper periodically according to TTL

 

timer.

-gkfind

gatekeeper finding port. Port number, which VoIP FXO gateway

 

uses it to discover a gatekeeper. Default value is 1718.

-gwtype

to set VoIP FXO gateway register mode as terminal or gateway. 0

 

is for terminal and 1 is for gateway. If set VoIP FXO gateway as

 

terminal mode, it must be set sysconf –2nddial 1(refer to 5.12).

-ras

to set default gatekeeper RAS port number. Default value, 1719,

 

is well-known port for RAS communication.

-range

to allocate dynamic port range, which VoIP FXO gateway may

 

use.

-respto

response timeout. Max waiting time for 1st response to a new call

 

(1~200).

-connto

connection timeout. Max waiting time for call establishment after

 

receiving 1st response of a new call (1~20000).

5.15 [gk] command

This command is to configure embedded simple gatekeeper parameters. If user doesn’t have a gatekeeper or Micronet Call Manager, VoIP FXO gateway provides a simple embedded gatekeeper for up to 10 endpoints.

usr/config$ gk

Gatekeeper information and configuration

32

Image 32
Contents User’s Manual Introduction Features and specification General FeaturesAudio feature IntroductionBack panel Management FeaturesAppearance Pin Name Dir Description GNDSystem Operating Procedure StartIP Environment Setting Hyper Terminal SettingSystem Requirement Telephone Line RequirementPage Page Initializing VoIP FXO Gateway Setting Gatekeeper ModeConfigure VoIP FXO gateway Password Peer-to-Peer Mode Usr/config$ ifaddr -ip 10.1.1.1 -mask 255.2555.255.0 -gateUsr/config$ h323 -mode 0 -gk 10.2.2.2 -e164 -alias fxo Usr/config$ h323 -modeBehind IP-Sharing Usr/config$ pbook -add name TEST1 ip 10.1.1.1 e164Fixed IP Address usr/config$ ifaddr -ipsharing 1 Dynamic IP Address -usr/config$ ifaddr -ipsharing How to configure disconnect tone on VoIP FXO gateway Disconnect Tone ConfigurationWhat is Disconnect Tone There are two ways to analyze the disconnect tone Adjust Tone Table parameters manuallyExamples how to configure Tone table Adjust Input Tone Level Command lists Help commandQuit command Debug commandUsr/config$ debug -add h323 vp usr/config$ debug -open Reboot commandFlash command Commit command Ifaddr commandTime command Ping commandUsr/config$ ifaddr -sntp 1 Usr/config$ time Current time is THU JAN 01 052923Greetrd command Exit exit this command Pbook command Parameter UsagesPhonebook Rules Automatic sequence number as indexSysconf command PppoeLineToLine feature should be used together with $h323 -mode 1 peer-to-peer mode$sysconf -2nddial 1 2nddial on $bureau PrintPlease refer to 5.21 bureau command $bureau 192.168.4.184Value is set to enable all ports 14 h323 command Usr/config$ sysconf -sendxcode 1 -access set1Page Gk command Usr/config$ gk Gatekeeper information and configurationVoice command Display voice codec information and configuration Usr/config$ voice -mindelay 90 -maxdelay 150 -optfacor Tos commandUsr/config$ voice -nscng g723 Tone command Support commandGroup command Bureau command Usr/config$ group -pattern 1 3 -e164 100Page Prefix command Rom commandPage Passwd command TFTP/FTP server Upgrade the VoIP FXO gatewayDownload Procedure Page Appendix Web configuration Browse the IP Address which has predefined via RS-232Input the login name and password Start configure Network InterfaceH323 Information System Config Voice Setting For Advanced User Phone Pattern For Advanced User Page Phone Book For Peer-to-Peer mode only Type Of Service Hot Lines PPPoE Password ROM Upgrade Flash Clean Commit Data Reboot System