MicroNet Technology SP5054, SP5050, SP5052 user manual Voice Setting For Advanced User

Page 50

1.4 Voice Setting (For Advanced User)

zFrame Size: It got wrong order with “Codec Priority”. Select the Codec Priority. (For Advanced User)

zCodec Priority: It got wrong order with “Frame Size”. Select the packet size in sending process. (For Advanced User)

zG.723 Silence Suppression: Enable / Disable (For Advanced User)

zVolume: Adjust the volume in “Voice” (sending out); “Input” (receiving); “ DTMF” (DTMF sending out) Please Noted the value is limited.

zEcho Cancel: Enable / Disable (suggested always Enable)

zJitter Buffer: Min. Delay and Max. Delay (For Advanced User)

zOptimized Factor (Jitter): (For Advanced User)

50

Image 50
Contents User’s Manual Introduction Audio feature Features and specificationGeneral Features IntroductionBack panel Management FeaturesAppearance Pin Name Dir Description GNDSystem Operating Procedure StartSystem Requirement IP Environment SettingHyper Terminal Setting Telephone Line RequirementPage Page Initializing VoIP FXO Gateway Setting Gatekeeper ModeConfigure VoIP FXO gateway Password Usr/config$ h323 -mode 0 -gk 10.2.2.2 -e164 -alias fxo Peer-to-Peer ModeUsr/config$ ifaddr -ip 10.1.1.1 -mask 255.2555.255.0 -gate Usr/config$ h323 -modeBehind IP-Sharing Usr/config$ pbook -add name TEST1 ip 10.1.1.1 e164Fixed IP Address usr/config$ ifaddr -ipsharing 1 Dynamic IP Address -usr/config$ ifaddr -ipsharing How to configure disconnect tone on VoIP FXO gateway Disconnect Tone ConfigurationWhat is Disconnect Tone There are two ways to analyze the disconnect tone Adjust Tone Table parameters manuallyExamples how to configure Tone table Adjust Input Tone Level Quit command Command listsHelp command Debug commandUsr/config$ debug -add h323 vp usr/config$ debug -open Reboot commandFlash command Commit command Ifaddr commandUsr/config$ ifaddr -sntp 1 Time commandPing command Usr/config$ time Current time is THU JAN 01 052923Greetrd command Exit exit this command Pbook command Parameter UsagesPhonebook Rules Automatic sequence number as indexSysconf command Pppoe$sysconf -2nddial 1 2nddial on LineToLine feature should be used together with$h323 -mode 1 peer-to-peer mode $bureau PrintPlease refer to 5.21 bureau command $bureau 192.168.4.184Value is set to enable all ports 14 h323 command Usr/config$ sysconf -sendxcode 1 -access set1Page Gk command Usr/config$ gk Gatekeeper information and configurationVoice command Display voice codec information and configuration Usr/config$ voice -mindelay 90 -maxdelay 150 -optfacor Tos commandUsr/config$ voice -nscng g723 Tone command Support commandGroup command Bureau command Usr/config$ group -pattern 1 3 -e164 100Page Prefix command Rom commandPage Passwd command TFTP/FTP server Upgrade the VoIP FXO gatewayDownload Procedure Page Appendix Web configuration Browse the IP Address which has predefined via RS-232Input the login name and password Start configure Network InterfaceH323 Information System Config Voice Setting For Advanced User Phone Pattern For Advanced User Page Phone Book For Peer-to-Peer mode only Type Of Service Hot Lines PPPoE Password ROM Upgrade Flash Clean Commit Data Reboot System