Lucent Technologies Network Access Module manual INA Module Maintenance Options, Error Events

INA Module Maintenance Options

Note – For T1 configurations, you can assign a channel to the router only if the channel is Unequipped from a switch perspective. For PRI configurations, you can assign a channel to the router only if the channel is not used in a B channel group or a line pool on the switch.

Note – For the router to recognize a change in channel assignments, you must reboot the router either from its command line interface or by pressing the reboot button on the INA module.

You can view a summary of DSU channel assignments by using the following sequence on your system programming console.

Menu: SysProg→ Start→ LinesTrunks→ More→ More→ CSU/DSU→

Slot#→ Enter→ ChannelSel→ Inspect

All channels are listed and marked with one of the selections shown in Table C-2:

Table C-2Inspect DSU Channel Assignments

Selection Description

RThe channel is assigned to the router.

SThe channel is assigned to the switch.

UThe channel is assigned to neither the router nor the switch.

Use the following sequence on your system programming console to unassign channels from the router.

Menu: SysProg→ Start→ LinesTrunks→ More→ More→ CSU/DSU→

Slot#→ Enter→ ChannelSel→ Channel#→ Delete

You must repeat this sequence for each channel to be unassigned from the router.

INA Module Maintenance Options

The 100R module has improved T1/PRI error event reporting and has an expanded set of demand tests. All 100D module maintenance options are also included.

Error Events

The INA module provides three additional error event counts as well as the ability to manually clear these error event counts. Included are

•24-hour event totals

•Current events

•Selected interval events

•Clearing error events

C-3