Lucent Technologies Network Access Module manual Using a Telnet Session, Log

Log In

Using a Telnet Session

Once the INA module has been connected to a network and an Ethernet address has been assigned, Telnet is the best way to establish a console session.

1.Run a Telnet application from a network connected workstation.

2.Select the connect function, and enter the IP address assigned to the INA module’s Ethernet port.

3.Press Enter if needed. A login prompt appears.

Using the Passthrough Serial Connection

1.Make sure that the serial passthrough cable has been connected to the INA module and the MERLN MAGIX processor module.

See “Connect a Serial Passthrough Cable” on page 3-1.

2.Use the MERLIN MAGIX WinSPM application on a PC workstation with a modem to dial up a connection to the MERLN MAGIX processor module.

Connect to *10 to access the modem.

3.Enter your MERLIN MAGIX system administration password and select the WinSPM Passthrough option.

4.Press Enter to receive a login prompt to the command line interface of the router.

Log In

Follow these steps to log in to the INA module:

1.At the login prompt, type !root and press Enter.

2.At the password prompt, press Enter—no password is needed for a first-time installation.

login: !root Password: Command>

Set the Administrative Password

The password is an ASCII-printable string of up to 16 characters used to access the INA module administrative features. Only a person with administrative access can change this password.

Enter the following commands to set the password:

5-2 INA Module Installation and Configuration Guide