Lucent Technologies Network Access Module manual 8Ethernet LEDs

Observe LED Behavior

After the module has been powered up and loading is complete, make sure that the LED is blinking off once every 5 seconds. The INA module takes about 20 seconds to reach this state.

Ethernet LEDs

These LEDs (Figure 3-8)show the status of the Ethernet connection to the INA module.

Figure 3-8Ethernet LEDs

network activity LED		Amber
	E
	T
	H
	E
	R
	N
	E
Ethernet Link LED	T	Green

1210-006

•The green link LED is on when the module has link integrity to a 10BaseT hub, switch, or router. Make sure that this LED lights when a cable has been connected between the module and an Ethernet hub. If the LED does not light, check the cable itself and the network connections.

•The amber network activity led blinks to indicate Ethernet traffic. During heavy traffic, this LED might appear solid due to its rapid blinking. Depending on your network, you might not necessarily see much traffic.

3-6 INA Module Installation and Configuration Guide