INSTALLATION
6.If you are installing power management software, connect your computer to one of the communication ports or optional connectivity card (see page 53). For the communication ports, use an appropriate cable (not supplied).
7.If an emergency
8.If you are installing EBM(s), continue to the following section, “Connecting the EBM(s).” Otherwise, continue to “UPS Initial Startup” on page 34.
Connecting the EBM(s)
To install the optional EBM(s) for a UPS:
1.On the rear of the UPS, remove the cable retention clip covering the battery connector. Retain the clip and screws. See Figure 16.
2.Installations with one EBM only. Remove the cable retention clip covering the right (for
3.Installations with more than one EBM. For all EBMs except the last EBM, remove the cable retention clips covering both battery connectors. Do not remove the clip from the second battery connector on the last EBM. Retain the clips and screws.
C A U T I O N
A small amount of arcing may occur when connecting an EBM to the UPS. This is normal and will not harm personnel. Insert the EBM cable into the UPS battery connector quickly and firmly.
4.Plug the EBM cable(s) into the battery connector(s) as shown in Figure 16. Up to four EBMs may be connected to the UPS.
5.For each cable retention clip removed, rotate the clip and install it under each EBM cable connection using the retained screws.
6.Verify that the EBM connections are tight and that adequate bend radius and strain relief exist for each cable.
7.Continue to “UPS Initial Startup” on page 34.
32 | Eaton® 9130 UPS |