Edimax Technology AR-7211B V2 manual IP QoS

Page 75

Entries in this table allow you to configure one IP pool for a specified source IP address from LAN, so one packet whose source IP is in the range of the specified address will select one IP address from the pool for NAT.

5.6.3.IP QoS

Choose Advanced > IP QoS, and the page shown in the following figure appears.

1.Enable IP QoS and click Apply to enable IP QoS function.

2.Click add rule to add a new IP QoS rule.

The page shown in the following figure appears. Entries in the QoS Rule List are used to assign the precedence for each incoming packet based on physical LAN port, TCP/UDP port number, source IP address, destination IP address and other information.

75

Image 75

Contents AR-7211A V2 / AR-7211B Copyright Contents Routing NAT IP QoS Snmp Others Package Contents Safety PrecautionsSystem Requirements Adsl LED & Button DefinitionsLAN  DMZ Features Napt  DNSConfiguration Connect the Adsl lineConnect the router to your LAN network No telephone before the splitter Firewall settings PC LAN IP configurationCheck the Adsl LED status Page Select Internet Protocol TCP/IP and then click Properties Page Windows Vista and Windows XP WindowsWindows Vista Windows XP Page Setup Wizard EZmax Setup WizardPlease select your product Page Page Page Page Internet Connection Type Parameter VPI VCI Bridge Mode Dynamic IP Address Static IP Firmware Upgrade Accessing the Router Web ConfigurationVCI Internet ConnectionField Description VPIPPPoE/PPPoA On Demand, or Manual 2 MER/1483 Routed Bridged Dhcp Server Field Description LAN Interface SetupLAN IP 192.168.2.1Device Info StatusWAN LANAdsl Statistic StatisticsNetwork ARPLAN IP Duplex,10Mbps/FullDuplex,10Mbps/Half Downlist100Mbps/FullDuplex,100Mbps/HalfCurrent Allowed MAC Address Table Current Allowed MAC Address Table can accessField Description Duplex,Auto Negotiation MACField Description Field Description If set to Dhcp Relay, the router acts a surrogate Dhcp WAN Dhcp Static IPMER, PPPoE, PPPoA, 1483 Routed or IPoA PPP Settings WAN IP SettingsOn Demand or Manual PVC into the Current ATM VC Table ATM VCC VPI/VCIIf you choose Connect on Demand Bridged PPPoE or Disable Bridge MaccloneAuto PVC ATM Settings CBR, nrt-VBR or rt-VBRPCR MBS Adsl SettingsCdvt SCRDNS ServiceDynDNS.org or TZO DdnsFirewall 2.1. IP/Port FilterMAC Filter URL Filter Software Forbidden Anti-DoSUpnp TR-069 Igmp ProxyURL ACSConnection Request ACL DebugTo the Current ACL Table You can choose Interface or IP Address Advanced RoutingStatic Route RIP NAT RIPVirtual Server  If User-defined Service Name is selected, youNAT Forwarding ALG NATPort Trigger NAT Exclude IP2.8 NAT IP Mapping FTP ALG PortIP QoS You can choose strict prior or WFQ You can choose stream based, 802.1p based or Dscp BasedSnmp You can choose Normal Service, Minimize CostMinimize Delay Maximize Reliability, Maximize Throughput, orField Description Others Client LimitUpdate AdminCommit/Reboot  Restore to the factory default configurationBackup/Restore Upgrade FirmwareLog PasswordTime NTP ConfigurationTraceroute DiagnosticPing PingOAM Loopback DscpDiag-Test Adsl Statistics255.255.255.0, respectively Trouble ShootingDeclaration of Conformity