Turn on the monitor and computer, Information

Step 3: Turn on the monitor and computer

First turn on the monitor, then turn on the computer.

The installation of your monitor is complete.

If necessary, use the monitor’s controls to adjust the picture.

If no picture appears on your screen

•Check that the monitor is correctly connected to the computer.

•If NO INPUT SIGNAL appears on the screen, confirm that your computer’s graphic board is completely seated in the correct bus slot.

•If you are replacing an old monitor with this model and OUT OF SCAN RANGE appears on the screen, reconnect the old monitor. Then adjust the computer’s graphic board so that the horizontal frequency is between 30 – 70 kHz, and the vertical frequency is between 48 – 120 Hz.

For more information about the on-screen messages, see “Trouble symptoms and remedies” on page 14.

Setup on various OS (Operating System)

This monitor complies with the “DDC” Plug & Play standard and automatically detects all the monitor’s information. No specific driver needs to be installed to the computer.

If you connect the monitor to your PC, and then boot your PC for the first time, the setup Wizard may be displayed on the screen. Click on “Next” several times according to the instructions from the Wizard until the Plug & Play Monitor is automatically selected so that you can use this monitor.

For customers using Windows NT4.0

Monitor setup in Windows NT4.0 does not use the display driver. Refer to the Windows NT4.0 instruction manual for further details on adjusting the resolution, refresh rate, and number of colors.

Selecting the on-screen menu language (LANGUAGE/

INFORMATION)

English, French, German, Italian, Spanish, Russian and Japanese versions of the on-screen menus are available. The default setting is English.

1Press the center of the control button.

See page 9 for more information on using the control button.

MENU	MENU
	E I T
	H - S I Z E / CENT ER
	V - S I Z E / CENT ER
	P I N / P I N	BA L ANCE
	KEY / KEY	BA L ANCE
	ROT A T I ON
	ZOOM
	COLOR
	L ANGUAGE / I NFORMA T I ON
	DEGAUSS / CANCE L MO I RE
	SE L ECT

2Move the control button m/M to highlight

LANGUAGE/INFORMATION and press the center of the control button again.

MENU	LANGUAGE / INFORMAT I ON


	ENGL I SH	FRAN A I S	GB
			GB

	DEUT SCH	I T A L I ANO
	ESPA OL
SE L ECT		E I T

3Move the control button m/M to select (LANGUAGE) and move </, to select a language.

•ENGLISH

•FRANÇAIS: French

•DEUTSCH: German

•ITALIANO: Italian

•ESPAÑOL: Spanish

• : Russian

•: Japanese

To close the menu

Press the center of the control button once to return to the main MENU, and press again selecting EXIT to return to normal viewing. If no buttons are pressed, the menu closes automatically after about 30 seconds.

To reset to English

Press the RESET button while the (LANGUAGE) menu is displayed on the screen.