5.Insert the new USB memory key into the USB connector.
6.Close the blade.
7.Install the blade in the enclosure.
8.Enter the System Setup and verify that the USB key is detected by the system.
Figure 14. Replacing the USB Memory Key
1. USB memory key connector | 2. USB memory key |
SD vFlash Card
Replacing The SD vFlash Card
1.Remove the blade from the enclosure.
2.If installed, remove the SD vFlash card from the card slot.
NOTE: The SD vFlash card slot is located underneath LOM riser card 1 and can be identified by the SD vFlash card slot identification label.
3.To install the SD vFlash card, insert the
NOTE: The slot is keyed to ensure correct insertion of the card.
4.Press inward on the card to lock it into the slot.
5.Install the blade in the enclosure.
42