Figure 16. Removing and Installing a Processor/DIMM Blank |
| ||
1. | processor socket | 2. | processor/DIMM blank |
3. | tabs (4) | 4. | heat sink retention screws (4) |
Installing A Processor/DIMM Blank
1.Remove the blade from the enclosure.
2.Open the blade.
3.If installed, remove the processor and heat sink.
4.Position the processor/DIMM blank on the system board with the holes on the tabs of the processor/ DIMM blank secured to the heat sink retention screws on the system board.
5.Install the cooling shroud.
6.Close the blade.
7.Install the blade in the enclosure.
44