Eicon Networks DIVA T/A ISDN Modem manual Alphabetical List of Supported AT Commands

Page 17

Alphabetical List of Supported

AT Commands

The following tables summarize, in alphabetical order, theAT Commands supported by the DIVA T/A. Go to the specified page number for more information on a particular command.

AT! Commands	18
AT% Commands	20
AT& Commands	21
AT* Commands	22
AT> Commands	23
AT@ Commands	24
Other AT Commands	25
S-Registers	26
AT$ (Utility) Commands	27
Mini-monitor Commands	28

Note: Command descriptions preceded by the word “static” indicates a static parameter. Changes made to static parameters do not take effect immediately (as opposed to “dynamic” parameters, where changes take effect the moment they are made). To implement a change to a static parameter, use the AT&Wn command; the changes will be implemented when you restart your system.

A list of command groups can be found on page 16.

DIVA T/A ISDN Modem Reference Guide ◆ Page 17

Image 17

Contents Diva T/A Isdn Modem Reference Guide Eight Edition July 206-193-08 Contents Diva T/A Isdn Modem Reference Guide What is ISDN?What is ISDN? Channel Isdn Communication ChannelsChannel Basic Rate Access Connecting to Isdn BRI and PRIWhat is Multilink PPP? What is BACP/BOD? What is DBA? What is Always On / Dynamic Isdn AO/DI? What is Data Compression? Locating AT Commands Locating AT Commands AT Command Groups Alphabetical List of Supported AT Commands Alphabetical List of Supported AT Commands AT! CommandsAlphabetical List of Supported AT Commands AT% Commands AT& Commands AT* Commands AT Commands AT@ Commands Other AT Commands Registers AT$ Utility Commands Mini-monitor Commands General AT Commands General AT Commands Values for n Isdn Configuration CommandsDefaults Isdn Configuration Commands Default1 None defaultINS-Net64, NI-1, or 5ESS, µ law will be used default AT!D3=nAT!N2=n Default null string this is an optional valueNumber. Numbers are separated by a semicolon AT!N3=nOn region 255 do not attempt 56k data call retry For more details, refer to the Rvscom documentationAT!X56=n COM Port Configuration Commands Ring COM Port Configuration CommandsUpon connection, the Diva T/A reports the DCE speed For example, ConnectCall Control Commands ATA Call Control CommandsATH Configuration Commands Configuration Commands AT!V0=n Use the default settingsProfile Commands Multilink PPP Commands Multilink PPP Commands Internet Protocol IP Endpoint Discriminator Class/AddressAT%M3=b3c665ac11 Always On / Dynamic Isdn AT Commands Always On / Dynamic Isdn AT Commands Will be opened after the delay specified by AT!X10 AT!X13=n when Bacp is disabled, seeDefault 1000 bytes AT!X14=nDefault AT!X22=n Default values for each setting, and is defined as followsAT!X18 Defined as followsAT!X25=n Default CF PPP overConnection numbers affects the range ofAT!X21. SeeAT!X21 AT!X26=nUtility Commands Internal TA access command reserved for VU Utility CommandsStart or display the Result of a Lapd trace Start or Display the Result of a PPP traceStart an AO/DI X.25 Trace Enter the monitor on the next resetSoft reset the unit and enter the monitor AT? Register CommandsRegister Commands Analog Device Commands AT*Fn Analog Device CommandsDisable. Recommended for modem/fax calls To be disabledEnable with default values default Enable using same terminal endpoint identifier as data portMini-monitor Commands AT Command Result Codes Carrier Connect AT Command Result CodesConnect Connect 75T/1200R Protocol Transparent ModeConnect 1200T/75R Protocol NoneBACP/BOD Index