Eicon Networks DIVA T/A ISDN Modem manual Mini-monitor Commands

Page 28

Alphabetical List of Supported AT Commands

Mini-monitor Commands

These command are only available when you are in Mini-monitor mode; they are not available when you are in command mode. The commands AT$Y or AT$Z will enter the Mini-monitor; see page 27 for more information. These commands are all case sensitive.

at@dump	Dump Memory	62

at@d1	DRAM test	62

at@d2	Flash test	62

at@d3	ISDN internal loop back test	62

at@d4	ISDN external loop back test	62

at>F	Restore Profiles to Original Settings	62

at@load	Simulate a fault	62

at@load	Load New Firmware	62

at@md arg	Display memory	62

at@msg	Display Cause for Entering Monitor	62

at@quit	Exit the Mini-monitor mode.	62

DIVA T/A ISDN Modem Reference Guide ◆ Page 28

Image 28

Contents Diva T/A Isdn Modem Reference Guide Eight Edition July 206-193-08 Contents What is ISDN? Diva T/A Isdn Modem Reference GuideWhat is ISDN? Isdn Communication Channels ChannelChannel Connecting to Isdn BRI and PRI Basic Rate AccessWhat is Multilink PPP? What is BACP/BOD? What is DBA? What is Always On / Dynamic Isdn AO/DI? What is Data Compression? Locating AT Commands Locating AT Commands AT Command Groups Alphabetical List of Supported AT Commands AT! Commands Alphabetical List of Supported AT CommandsAlphabetical List of Supported AT Commands AT% Commands AT& Commands AT* Commands AT Commands AT@ Commands Other AT Commands Registers AT$ Utility Commands Mini-monitor Commands General AT Commands General AT Commands Defaults Isdn Configuration CommandsValues for n Isdn Configuration Commands None default Default1INS-Net64, NI-1, or 5ESS, µ law will be used default AT!D3=nDefault null string this is an optional value AT!N2=nNumber. Numbers are separated by a semicolon AT!N3=nAT!X56=n For more details, refer to the Rvscom documentationOn region 255 do not attempt 56k data call retry COM Port Configuration Commands COM Port Configuration Commands RingFor example, Connect Upon connection, the Diva T/A reports the DCE speedCall Control Commands Call Control Commands ATAATH Configuration Commands Configuration Commands Use the default settings AT!V0=nProfile Commands Multilink PPP Commands Multilink PPP Commands AT%M3=b3c665ac11 Endpoint Discriminator Class/AddressInternet Protocol IP Always On / Dynamic Isdn AT Commands Always On / Dynamic Isdn AT Commands AT!X13=n when Bacp is disabled, see Will be opened after the delay specified by AT!X10Default 1000 bytes AT!X14=nDefault values for each setting, and is defined as follows Default AT!X22=nAT!X18 Defined as followsDefault CF PPP over AT!X25=nConnection numbers affects the range ofAT!X21. SeeAT!X21 AT!X26=nUtility Commands Utility Commands Internal TA access command reserved for VUStart or display the Result of a Lapd trace Start or Display the Result of a PPP traceSoft reset the unit and enter the monitor Enter the monitor on the next resetStart an AO/DI X.25 Trace Register Commands AT?Register Commands Analog Device Commands Analog Device Commands AT*FnTo be disabled Disable. Recommended for modem/fax callsEnable with default values default Enable using same terminal endpoint identifier as data portMini-monitor Commands AT Command Result Codes Connect AT Command Result CodesCarrier Connect Protocol Transparent Mode Connect 75T/1200RConnect 1200T/75R Protocol NoneIndex BACP/BOD