Eicon Networks DIVA T/A ISDN Modem manual Multilink PPP Commands

Multilink PPP Commands

The following table describes the MLPPP configuration commands.

AT%M1=n	Local Endpoint Discriminator Class. The value for ‘n’ specifies the Local Endpoint
	Discriminator Class. If you specify n=1 (class 1), the Local Endpoint Discriminator
	Address (specified with AT%M3=n) must be an even number. For a list of classes, see
	“Endpoint Discriminator Class/Address” on page 48.
AT%M2=n	Remote Endpoint Discriminator Class. The value for ‘n’ specifies the Remote
	Endpoint Discriminator Class. For a list of classes, see “Endpoint Discriminator
	Class/Address” on page 48.
AT%M3=n	Local Endpoint Discriminator Address. The value for ‘n’ specifies the Local
	Endpoint Discriminator Address. For a description of permitted addresses, see
	“Endpoint Discriminator Class/Address” on page 48.
AT%M4=n	Remote Endpoint Discriminator Address. The value for ‘n’ specifies the Remote
	Endpoint Discriminator Address. For a description of permitted addresses, see
	“Endpoint Discriminator Class/Address” on page 48.
AT%P5=n	Bandwidth Allocation Control Protocol (BACP) / Bandwidth on Demand (BOD).
	This command specifies whether BACP/BOD is enabled or disabled. When enabled,
	the DIVA T/A will drop to one B channel (reducing costs) when throughput drops
	below 64K. The DIVA T/A first attempts to negotiate BACP; if this is unsuccessful, the
	DIVA T/A falls back to BOD.
	n=0	Disable (default).
	n=1	Enable.
	Note: You can use this parameter only if the DIVA T/A has been configured for MLPPP.
AT%P6=n	Set Initial Billing Interval Timer. Sets the timer (in seconds) to match the amount of
	time your ISDN provider allocates as the first time interval.
	Note: If the value is set to 0, the timer is not used. Setting this value to 0, also
	effectively sets AT%P7 to 0.
	Range: 0 to 65535.
	Default: 60 seconds.
AT%P7=n	Set Billing Interval Timer. Sets the timer (in seconds) to match the amount of time
	your ISDN provider designates as the minimum chargeable unit for all subsequent
	billing.
	Note: If the value is set to 0, the timer is not used.
	Range: 0 to 65535.
	Default: 60 seconds.

DIVA T/A ISDN Modem Reference Guide ◆ Page 46