Eicon Networks DIVA T/A ISDN Modem manual Register Commands

Page 58

S-Register Commands

Register	Description
S25	Data Terminal Ready Detection Delay. Specifies the duration that the Data
	Terminal Ready (DTR) status must either be raised or dropped before being
	recognized by the DIVA T/A. This delay helps ensure that the DIVA T/A does not
	interpret a random glitch as a DTR raise or drop.
	This register affects the AT&Dn command, which controls interpretation of the Data
	Terminal Ready (DTR) input (see page 37). Essentially, detection by AT&Dn will be
	delayed according to the S25 register setting.
	Range: 0-255, in tenths of a second. For example, if set to 5, the duration is five-tenths
	of a second, or 50 milliseconds.
	Default: 0. Type: Storable.

DIVA T/A ISDN Modem Reference Guide ◆ Page 58

Image 58

Contents Diva T/A Isdn Modem Reference Guide Eight Edition July 206-193-08 Contents What is ISDN? Diva T/A Isdn Modem Reference GuideWhat is ISDN? Isdn Communication Channels ChannelChannel Connecting to Isdn BRI and PRI Basic Rate AccessWhat is Multilink PPP? What is BACP/BOD? What is DBA? What is Always On / Dynamic Isdn AO/DI? What is Data Compression? Locating AT Commands Locating AT Commands AT Command Groups Alphabetical List of Supported AT Commands AT! Commands Alphabetical List of Supported AT CommandsAlphabetical List of Supported AT Commands AT% Commands AT& Commands AT* Commands AT Commands AT@ Commands Other AT Commands Registers AT$ Utility Commands Mini-monitor Commands General AT Commands General AT Commands Defaults Isdn Configuration CommandsValues for n Isdn Configuration Commands INS-Net64, NI-1, or 5ESS, µ law will be used default None defaultDefault1 AT!D3=nNumber. Numbers are separated by a semicolon Default null string this is an optional valueAT!N2=n AT!N3=nAT!X56=n For more details, refer to the Rvscom documentationOn region 255 do not attempt 56k data call retry COM Port Configuration Commands COM Port Configuration Commands RingFor example, Connect Upon connection, the Diva T/A reports the DCE speedCall Control Commands Call Control Commands ATAATH Configuration Commands Configuration Commands Use the default settings AT!V0=nProfile Commands Multilink PPP Commands Multilink PPP Commands AT%M3=b3c665ac11 Endpoint Discriminator Class/AddressInternet Protocol IP Always On / Dynamic Isdn AT Commands Always On / Dynamic Isdn AT Commands Default 1000 bytes AT!X13=n when Bacp is disabled, seeWill be opened after the delay specified by AT!X10 AT!X14=nAT!X18 Default values for each setting, and is defined as followsDefault AT!X22=n Defined as followsConnection numbers affects the range ofAT!X21. SeeAT!X21 Default CF PPP overAT!X25=n AT!X26=nUtility Commands Start or display the Result of a Lapd trace Utility CommandsInternal TA access command reserved for VU Start or Display the Result of a PPP traceSoft reset the unit and enter the monitor Enter the monitor on the next resetStart an AO/DI X.25 Trace Register Commands AT?Register Commands Analog Device Commands Analog Device Commands AT*FnEnable with default values default To be disabledDisable. Recommended for modem/fax calls Enable using same terminal endpoint identifier as data portMini-monitor Commands AT Command Result Codes Connect AT Command Result CodesCarrier Connect Connect 1200T/75R Protocol Transparent ModeConnect 75T/1200R Protocol NoneIndex BACP/BOD