7Replace the computer cover, (see page 93).
NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer.
8Connect your computer and devices to electrical outlets, and turn them on.
9
10Click the General tab.
11To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
Removing Memory
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
1Follow the procedures in "Before You Begin" on page 55.
2Press out the securing clip at each end of the memory module connector.
3Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.
Cards
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
68