Dell 200 Controls and Lights Power control Push button Power light, State, Problems on

Controls and Lights

Power control	push button
Power light	green light — Blinking green in sleep state; solid green for power-on
	state.
	amber light — Blinking amber indicates a problem with an installed
	device; solid amber indicates an internal power problem (see "Power
	Problems" on page 38).
Hard-drive access light	green
Link integrity light (on integrated	green light — A good connection exists between a 10-Mbps
network adapter)	network and the computer.
	orange light — A good connection exists between a 100-Mbps
	network and the computer.
	off (no light) — The computer is not detecting a physical
	connection to the network.
Activity light (on integrated network	yellow blinking light
adapter)
Diagnostic lights	four lights on the front panel (See "Diagnostic Lights" on page 45 for
	an explanation of the diagnostic light codes.)
Standby power light	AUX_PWR on the system board
Activity light (optional Media Card	green blinking light
Reader)
Power
DC power supply:
Wattage	275 W
Heat dissipation	939 BTU/hr

Voltage (See the safety instructions in the Product Information Guide for important voltage setting information.)

NOTE: Heat dissipation is calculated based upon the power supply wattage rating.

manual selection power supplies — 90 to 135 V at 50/60 Hz; 180 to 265 V at 50/60 Hz

Backup battery 3-V CR2032 lithium coin cell

98

Appendix