Dell 200 owner manual Replacing the External Modem Connector

2Remove the existing modem:

a Disconnect the modem cable from the modem.

b Use a small Phillips screwdriver to remove the two screws securing the modem to the system board, and set the screws aside.

c Pull straight up on the attached pull-tab to lift the modem out of its connector on the system board.

NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors and realign the card.

3Install the new modem:

a Align the modem with the screw holes and press the modem into the connector on the system board.

b Connect the modem cable to the modem.

c Use a Phillips screwdriver to replace and tighten the two screws that secure the modem to the system board.

4Replace the computer cover (see page 93).

Replacing the External Modem Connector

1Follow the procedures in "Before You Begin" on page 55.

2Remove the modem cable from the modem.

3Remove the existing modem (see page 89).

NOTE: Note the routing of the modem cable as you remove the modem. You must route the cable properly when you replace the modem to prevent the cable from being pinched or crimped.

4Remove the modem cable from the modem.

5Remove the external modem connector:

a Remove the screw that secures the external modem connector.

b Slide the external modem connector away from the slot that holds the modem connector in place.

c Lift the modem cable and connector from the computer.

90

Removing and Installing Parts