S y s t e m B o a r d E x p a n s i o n C a r d C o m p o n e n t s
32-bit,
33 MHz
AGP connector
PCI connector 1
PCI connector 2
PCI connector 3
64-bit,
66 MHz
PCI connector 4
PCI connector 5
NOTE: Install only
Installing an Expansion Card
CAUTION: Before you perform this procedure, see "Safety First— For You and Your Computer."
NOTICE: Before disconnecting a device from the computer, wait 10 to 20 seconds after disconnecting the computer from its electrical outlet. Before removing a component from the system board, verify that the standby power light on the system board has turned off. To locate this light, see "System Board Components" or the interior service label.
1Turn off the computer and devices, disconnect them from their electrical outlets, and wait 10 to 20 seconds.
2Lay the computer on its right side.
3Open the computer cover.
4Press the lever on the expansion card retention arm and raise the retention arm (see the following figure).