Jumper Settings
The following figure shows the location of the jumpers on the system board.
S y s t e m B o a r d J u m p e r s
PSWD
RTCRST
NOTICE: Before changing a jumper setting, verify that the standby power light on the system board has turned off. Otherwise, damage to your computer or unpredictable results may occur. To locate this light, see "System Board Components" or the interior service label.
To change a jumper setting, pull the plug off its pin(s) and carefully fit it down onto the pin(s) indicated.
The following table lists the system board jumpers and their settings.
S y s t e m - B o a r d J u m p e r S e t t i n g s
Jumper | Setting | Description |
PSWD | (default) | Password features are enabled. |
|
| Password features are disabled. |
RTCRST
jumpered
unjumpered
Advanced Features
55