1Turn off the computer and devices, disconnect them from their electrical outlets, and wait 10 to 20 seconds.
2Lay the computer on its right side.
3Open the computer cover.
4Remove the jumper plug from the PSWD jumper to disable the password feature.
See "Jumper Settings" to locate the password jumper (labeled "PSWD") on the system board.
5Close the computer cover.
6Stand the computer upright.
7Reconnect the computer and devices to their electrical outlets, and turn them on.
The existing password(s) are erased.
NOTE: If enabled, the Chassis Intrusion option will cause the following message to be displayed at the next system
ALERT! Cover was previously removed.
8Proceed to step 9 if you want to assign a new password.
NOTE: Before you assign a new system and/or setup password, you must install the PSWD jumper plug to reenable the password feature.
9Turn off the computer and devices, disconnect them from their electrical outlets, and wait 10 to 20 seconds.
10Lay the computer on its right side.
11Open the computer cover.
12Install the PSWD jumper plug.
13Close the computer cover.
14Stand the computer upright.
15Reconnect the computer and devices to their electrical outlets, and turn them on.
Turning on your computer with the PSWD jumper installed reenables the password feature. When you enter system setup, both password
Advanced Features
53