w w w . d e l l . c o m s u p p o r t . d e l l . c o m
14When the System Memory total is correct, exit system setup.
15Run the Dell Diagnostics to verify that the memory modules are operating properly.
Removing a Memory Module
NOTICE: Before disconnecting a device from the computer, wait 10 to 20 seconds after disconnecting the computer from its electrical outlet. Before removing a component from the system board, verify that the standby power light on the system board has turned off. To locate this light, see "System Board Components" or the interior service label.
NOTICE: To avoid damage to the memory module, press the securing clips with equal force applied at each end of the memory socket.
1Press the securing clips at each end of the memory socket outward simultaneously until the module pops out slightly from the socket (see the following figure).
NOTE: To access the securing clips on the system board memory sockets, it may be necessary to remove the fan for microprocessor 0. For instructions on removing and installing the processor fan, see the Service Manual.
2Lift the module away from the socket.
Re m o v i n g a M e m o r y M o d u l e
securing clips (2)
memory socket
78