Olivetti ECR 6900 manual PLU Sales Report, PLU Range Sales Report, Department Range Sales Report

PLU Sales Report

This report provides the number of times a particular PLU is used, the totals for that number and the sales total for all PLUs.

1.Control lock key position: X or Z (bear in mind that a Z PLU Report resets all PLU totals to zero).

2.If a PRG and Z mode, or X mode, manager password was defined type the [4-digit password] and press .

3.Press .

PLU
number or	PLU 1
assigned	sales
name	counter
PLU 1
sales total

Total PLU sales

PLU Range Sales Report

This report provides the same transaction information as the PLU Sales Report but pertaining to a defined range of PLUs.

1.Control lock key position: X only.

2.If an X mode manager password was defined, type the

[4-digit password] and press .

3.Type the PLU number [0001 - 2000] that you want to start from.

4. Press .

5.Type the PLU number [0001 - 2000] that you want to end with.

6.Press .

Department Range Sales Report

This report provides the number of transactions performed by the departments within the defined range, and their related sales totals.

1.Control lock key position: X only.

2.If an X mode manager password was defined, type the

[4-digit password] and press .

3.Type the department number [01-99]that you want to start from.

4.Type the department number [01-99]that you want to end with.

5.Press.

Department Group Sales Report

This report provides the same information as a Department Range Sales Report, but for all the departments associated with the defined department group.

1.Control lock key position: X only.

2.If an X mode manager password was defined, type the

[4-digit password] and press .

3.Type the department group number to . To issue a report containing the sales of the departments

of all the department groups, type .

4.Press .

Time Report

The time report provides the net total sales performed by the cash register on an hourly basis.

1.Control lock key position: X or Z (bear in mind that a Z time report resets all time totals to zero).

2.If a PRG and Z mode, or X mode, manager password was

defined type the [4-digit password] and press .

3. Type and then press .

Training Report

This report provides an X or Z report of the transactions performed in the training mode. Like the ordinary X and Z financial reports, a Z report resets all transaction totals to zero and provides the same information as an ordinary X or Z financial report with the exception that the report identifier is "X0" or "Z0".

1.Control lock key position: X or Z. Bear in mind that in the Z position the training report contents are cleared.

2.If a training mode password was defined, type the

[4-digit password] and press .

3. Press .

Electronic Journal Reports

An electronic journal report executed with the control switch in the X position does not clear the electronic journal memory (and therefore all transaction data are retained) while the report executed with the control switch in the Z position cancels electronic journal memory thus re- storing it to its maximum13,000 line capacity pro- grammed.

To momentarily interrupt report printing, press . Press

this key again to resume printing (for example, to load paper and avoid an out-of-paper condition).

To cancel report printing, press .

22