Sunway NT 10000 user manual

With Tyco Solarlok connectors, different	1.	Bare the de-energised line by 8 mm
kinds of annular contacts are used for dif-
ferent conductor cross-sections. Make sure	2.	Crimp the annular contact
to use the right tools for these cross-sec-
tions. The enclosed Tyco Solarlok connec-	3. Slide the gland, the compression sleeve,
tors are equipped with annular contacts		and the seal onto the line
for a cable cross-section of 4 mm. The
enclosed seals have an internal diameter of	4.	Engage the contact in the connector
6 mm (for lines with a cladding diameter		housing
of 5.3 to 6.2 mm) and 8 mm (for lines with
			GB
a cladding diameter of 7.2 to 8.0 mm).	5.	Screw the lock nut on
Make sure to use a seal that fits the clad-
ding diameter of the cable used.	6.	Tightening torque for the cable gland:
		1.5 Nm
When installing the Tyco Solarlok connec-
tors, proceed in the following order:

155