Savin 8700W manual Switching the Fusing Temperature

Page 14

BASIC

Switching the Fusing Temperature

When you make a copy on translucent paper or transparent film, switch the fusing unit temperature to stabilize toner fusing.

SIf you make a copy in the condition unsuitable for copy paper, the copy might be creased or a part of the image might not be copied.

STurn on the "HIGH" indicator for translucent paper and "LOW" for transpar- ent film. The time required for changing the fusing temperature for the standard paper to that for the "HIGH" or "LOW" setting is as follows. This time might vary depending on the copier condition.

∙HIGH - About 3 minutes

∙LOW - About 5 minutes

SThe fusing temperature is switched automatically when you change the paper type. When you want to make a copy immediately, press the Fusing Temperature key to return the fusing temperature to the one set before switching.

SWhen you specify a different width of roll paper, the fusing temperature might be switched automatically.

SWhen you set the fusing temperature to "HIGH", the paper curls easily. Uncurl such copies before stocking them.

1 Press the Fusing Temperature key to turn on the "HIGH" or "LOW" indicator.

The "Wait" indicator goes on and either the "HIGH" or "LOW" indicator is lit.

✏When the "Wait" indicator goes off and the "Ready" indiator goes on, the copier enters the ready condition.

COPYING 7

Image 14

Contents Operating Instructions Ifor the main switch Introduction Safety InformationSafety During Operation Examples Of IndicationsSafety Information Safety Information Table of Contents What to do if Something Goes Wrong Copier Exterior Main UnitIndicator Panel Operation PanelCopying Basic Recommended OriginalsRecommended Paper Copying Switching the Fusing Temperature Setting the Number of Copies Repeated Copying Adjusting Copy Density Press the Lighter and Darker keys to adjust copy densitySwitching the Copy Exit Copying Setting a Leading/Trailing Edge Margin Copying Copying Onto Roll Paper Synchro CuttingPreset Cutting Copying Variable Cutting Copying Partial Copying Partial Copying Sample Copying Paper TYPE/ROLL Width Entry Function Press the Fusing Temperature key to select the paper type Using the Program Function Programming a Collection of Copy SettingsUsing the Program Function Recalling Programmed Settings Copying with Manual Feed Copying with Manual Feed What to do if Something Goes Wrong When the Wait Indicator is LIT Spotty or Partially Blank Copies Dirty CopiesBlurred Copies Waved Copies Creased CopiesWhen a or x is LIT When a and Are Lit When x and Are Lit What to do if Something Goes Wrong When Is Lit When C is LIT When C is LIT What to do if Something Goes Wrong Cutting the Paper Automatically Cutting the Paper Manually When D is LIT or Blinking When D is LIT or Blinking What to do if Something Goes Wrong Page Maintaining Your Copier Functions That can be Reset Copy MAGNIFICATION/CUT Length Adjustment Copy MAGNIFICATION/CUT Length Adjustment DO’S and DON’TS DO’S and DON’TS Daily Maintenance PAPER/TONER TonerWhere to PUT Your Copier Installation ConditionsSpace Required for Installing the Copier DisposalPower Connection Page Specifications Specifications Spirio 700W3rd Roll Feeder ISOOther Options