Savin 8700W manual Partial Copying

Page 26

PARTIAL COPYING

The Partial Copy function copies only a part of an original.

This function specifies the start and end points in the original feed direction.

SThe Partial Copy function cannot apply to originals having a length of less than 245 mm, 9.6" in the paper feed direction.

SThe Partial Copy function cannot be used in the rear table.

SThe Partial Copy function cannot be used when the Sample Copy function is selected.

SThe start and end points cannot be set within 162 mm, 6.4" from the leading edge of paper.

SThe spacing between the start and end points is 100 mm, 4.0" at the minimum.

SRoll paper is cut in 250 mm, 9.9" at the minimum.

1 Press the Partial Copy key. The indicator on the Partial Copy key blinks.

✏When you press the Partial Copy key again, the leading edge of an original becomes the start point for partial copying. When you press the Partial Copy key for the third time, you can cancel partial copying.

2Set your original.

The copier starts copying.

✏Do not release the original until it is fed into the copier.

COPYING 19

Image 26

Contents Operating Instructions Ifor the main switch Introduction Safety InformationSafety During Operation Examples Of IndicationsSafety Information Safety Information Table of Contents What to do if Something Goes Wrong Copier Exterior Main UnitIndicator Panel Operation PanelCopying Basic Recommended OriginalsRecommended Paper Copying Switching the Fusing Temperature Setting the Number of Copies Repeated Copying Adjusting Copy Density Press the Lighter and Darker keys to adjust copy densitySwitching the Copy Exit Copying Setting a Leading/Trailing Edge Margin Copying Copying Onto Roll Paper Synchro CuttingPreset Cutting Copying Variable Cutting Copying Partial Copying Partial Copying Sample Copying Paper TYPE/ROLL Width Entry Function Press the Fusing Temperature key to select the paper type Using the Program Function Programming a Collection of Copy SettingsUsing the Program Function Recalling Programmed Settings Copying with Manual Feed Copying with Manual Feed What to do if Something Goes Wrong When the Wait Indicator is LIT Spotty or Partially Blank Copies Dirty CopiesBlurred Copies Waved Copies Creased CopiesWhen a or x is LIT When a and Are Lit When x and Are Lit What to do if Something Goes Wrong When Is Lit When C is LIT When C is LIT What to do if Something Goes Wrong Cutting the Paper Automatically Cutting the Paper Manually When D is LIT or Blinking When D is LIT or Blinking What to do if Something Goes Wrong Page Maintaining Your Copier Functions That can be Reset Copy MAGNIFICATION/CUT Length Adjustment Copy MAGNIFICATION/CUT Length Adjustment DO’S and DON’TS DO’S and DON’TS Daily Maintenance PAPER/TONER TonerWhere to PUT Your Copier Installation ConditionsSpace Required for Installing the Copier DisposalPower Connection Page Specifications Specifications Spirio 700W3rd Roll Feeder ISOOther Options