Savin 8700W manual Switching the Copy Exit

Page 17

BASIC

Switching the Copy Exit

This function switches the copy exit direction to the upper or lower according to the copy paper size.

SSelect the lower copy exit when copying onto A0, 36" × 48" K or A1, 24" × 36" K paper. If you use the upper copy exit to copy onto these paper, delivered copies might remain inside the copier causing a paper jam.

SSelect the upper copy exit when copying onto A4 K or 9" × 12" K paper. If you select the lower copy exit, copies might not be stocked properly.

SWhen you turn on the copier, the message "upper copy exit" lights.

SYou can stock the following number of copies by using the upper copy exit. If you stock copies exceeding these numbers, the paper might be jammed or the image might be copied on the underside of the paper.

∙A4 L ~ A1 K , A L ~ D K - 25 sheets

∙Translucent paper - 10 sheets

SWhen you select the lower copy exit and take copies out of the rear side of the copier, you can stock up to 10 copies for A0, 36" × 48" K or A1, 24" × 36" K paper.

SWhen you select the lower copy exit and take copies out of the front side of the copier, you can stock only one copy.

SWhen you copy onto A3, short grain paper, you can stock less copies than those for A3, long grain paper.

1 Press the Copy Exit key to select the direction in which copies are delivered.

✏" " lights for the upper copy

exit and " " for the lower copy exit.

10 COPYING

Image 17

Contents Operating Instructions Ifor the main switch Safety During Operation Safety InformationIntroduction Examples Of IndicationsSafety Information Safety Information Table of Contents What to do if Something Goes Wrong Main Unit Copier ExteriorOperation Panel Indicator PanelCopying Recommended Originals BasicRecommended Paper Copying Switching the Fusing Temperature Setting the Number of Copies Repeated Copying Press the Lighter and Darker keys to adjust copy density Adjusting Copy DensitySwitching the Copy Exit Copying Setting a Leading/Trailing Edge Margin Copying Synchro Cutting Copying Onto Roll PaperPreset Cutting Copying Variable Cutting Copying Partial Copying Partial Copying Sample Copying Paper TYPE/ROLL Width Entry Function Press the Fusing Temperature key to select the paper type Programming a Collection of Copy Settings Using the Program FunctionUsing the Program Function Recalling Programmed Settings Copying with Manual Feed Copying with Manual Feed What to do if Something Goes Wrong When the Wait Indicator is LIT Spotty or Partially Blank Copies Dirty CopiesBlurred Copies Creased Copies Waved CopiesWhen a or x is LIT When a and Are Lit When x and Are Lit What to do if Something Goes Wrong When Is Lit When C is LIT When C is LIT What to do if Something Goes Wrong Cutting the Paper Automatically Cutting the Paper Manually When D is LIT or Blinking When D is LIT or Blinking What to do if Something Goes Wrong Page Maintaining Your Copier Functions That can be Reset Copy MAGNIFICATION/CUT Length Adjustment Copy MAGNIFICATION/CUT Length Adjustment DO’S and DON’TS DO’S and DON’TS Daily Maintenance Toner PAPER/TONERInstallation Conditions Where to PUT Your CopierDisposal Space Required for Installing the CopierPower Connection Page Specifications Spirio 700W SpecificationsISO 3rd Roll FeederOther Options