Savin 8700W manual DO’S and DON’TS

Page 58

DO’S AND DON’TS

SSince some parts of the copier are supplied with high electrical voltage, touch only the parts specified in this manual.

SWhile copying, do not turn off the main switch. When you turn off the copier, confirm that all copy runs have finished.

SDo not step on or trip on the power cord.

SDo not unplug the power cord even after copying. This copier has the anticondensation heaters to protect the internal parts from dew when the ambient temperature changes. If you unplug the power cord, the anticon- densation heaters do not work. However, disconnect the power cord for safety when you will not use the copier for a long period.

SDo not open the original cover, original table, paper path section, and roll feeder during copying. Otherwise, the copier stops a copy run causing a paper jam.

SDo not move or slant the copier during copying.

SDo not remove or attach from and to the copier any screws or parts other than those specified in this manual.

SDo not allow paper clips, staples, or other small metallic objects to fall inside the machine.

SDo not spill water or other liquid on the copier.

SDo not lean on the rear cover.

SDo not obstruct the ventilation hole by placing or leaning an object in front of the hole. The ventilation hole protects the temperature from rising inside the copier. If the temperature rises excessively inside the machine, a fault might occur.

MAINTAINING YOUR COPIER 51

Image 58

Contents Operating Instructions Ifor the main switch Introduction Safety InformationSafety During Operation Examples Of IndicationsSafety Information Safety Information Table of Contents What to do if Something Goes Wrong Copier Exterior Main UnitIndicator Panel Operation PanelCopying Basic Recommended OriginalsRecommended Paper Copying Switching the Fusing Temperature Setting the Number of Copies Repeated Copying Adjusting Copy Density Press the Lighter and Darker keys to adjust copy densitySwitching the Copy Exit Copying Setting a Leading/Trailing Edge Margin Copying Copying Onto Roll Paper Synchro CuttingPreset Cutting Copying Variable Cutting Copying Partial Copying Partial Copying Sample Copying Paper TYPE/ROLL Width Entry Function Press the Fusing Temperature key to select the paper type Using the Program Function Programming a Collection of Copy SettingsUsing the Program Function Recalling Programmed Settings Copying with Manual Feed Copying with Manual Feed What to do if Something Goes Wrong When the Wait Indicator is LIT Blurred Copies Dirty CopiesSpotty or Partially Blank Copies Waved Copies Creased CopiesWhen a or x is LIT When a and Are Lit When x and Are Lit What to do if Something Goes Wrong When Is Lit When C is LIT When C is LIT What to do if Something Goes Wrong Cutting the Paper Automatically Cutting the Paper Manually When D is LIT or Blinking When D is LIT or Blinking What to do if Something Goes Wrong Page Maintaining Your Copier Functions That can be Reset Copy MAGNIFICATION/CUT Length Adjustment Copy MAGNIFICATION/CUT Length Adjustment DO’S and DON’TS DO’S and DON’TS Daily Maintenance PAPER/TONER TonerWhere to PUT Your Copier Installation ConditionsSpace Required for Installing the Copier DisposalPower Connection Page Specifications Specifications Spirio 700W3rd Roll Feeder ISOOther Options