Savin 8700W manual Where to PUT Your Copier, Installation Conditions

Page 62

WHERE TO PUT YOUR COPIER

This section shows the precautions you should follow when you move the copier if your office changes the equipment layout or moves to another location.

SWhen you move the copier, contact your service representative.

Installation Conditions

SInstall the copier in a location with the following range of temperature and humidity. Otherwise, the copier might not operate properly or the main frame might be deformed.

∙Temperature: 10 - 30 °C

∙Humidity: 15 - 90 %

SEven when the temperature and humidity fall within the ranges above, do not install the copier in the following locations:

∙Location subject to direct sunlight

∙Location near a heater, cooler, or humidifier

For customers using an ultrasonic humidifier

If you use tap or well water for an ultrasonic humidifier, impurities contained in the water become white powder and settle on the internal parts of the copier causing copies to be dirty. In particular, when you use the humidifier continuously for a long time, a humidifier demineralizer is recommended.

SInstall the copier on a flat, stable floor or base. If the floor or base is slant, you cannot make copies properly. The copier must be level within 5 mm both front to rear and left to right. If the copier is not stabilized, it might cause a fault as well as a danger to users.

SAvoid a location subject to vibrations, such as near a factory. Otherwise, a fault might occur due to the vibrations.

STo avoid a possible build-up of ozone, make sure to locate this copier in a large well ventilated room that has air turnover of more than 30m3/hr/person.

SInstall the copier in a location free from dust. If dust gets into the copier, a fault might occur.

MAINTAINING YOUR COPIER 55

Page 61 Page 63
Image 62
Page 61 Page 63
Contents Operating Instructions Ifor the main switch Introduction Safety InformationSafety During Operation Examples Of IndicationsSafety Information Safety Information Table of Contents What to do if Something Goes Wrong Copier Exterior Main UnitIndicator Panel Operation PanelCopying Basic Recommended OriginalsRecommended Paper Copying Switching the Fusing Temperature Setting the Number of Copies Repeated Copying Adjusting Copy Density Press the Lighter and Darker keys to adjust copy densitySwitching the Copy Exit Copying Setting a Leading/Trailing Edge Margin Copying Copying Onto Roll Paper Synchro CuttingPreset Cutting Copying Variable Cutting Copying Partial Copying Partial Copying Sample Copying Paper TYPE/ROLL Width Entry Function Press the Fusing Temperature key to select the paper type Using the Program Function Programming a Collection of Copy SettingsUsing the Program Function Recalling Programmed Settings Copying with Manual Feed Copying with Manual Feed What to do if Something Goes Wrong When the Wait Indicator is LIT Spotty or Partially Blank Copies Dirty CopiesBlurred Copies Waved Copies Creased CopiesWhen a or x is LIT When a and Are Lit When x and Are Lit What to do if Something Goes Wrong When Is Lit When C is LIT When C is LIT What to do if Something Goes Wrong Cutting the Paper Automatically Cutting the Paper Manually When D is LIT or Blinking When D is LIT or Blinking What to do if Something Goes Wrong Page Maintaining Your Copier Functions That can be Reset Copy MAGNIFICATION/CUT Length Adjustment Copy MAGNIFICATION/CUT Length Adjustment DO’S and DON’TS DO’S and DON’TS Daily Maintenance PAPER/TONER TonerWhere to PUT Your Copier Installation ConditionsSpace Required for Installing the Copier DisposalPower Connection Page Specifications Specifications Spirio 700W3rd Roll Feeder ISOOther Options
Top Page Image Contents