Savin 8700W manual Dirty Copies, Blurred Copies, Spotty or Partially Blank Copies

Page 38

IF YOUR COPIER DOES NOT OPERATE AS YOU WANT

The following table shows the causes of problems and the corrective actions when your copier does not operate as you want.

If the same problem remains even when you take the corresponding action, contact your service representative.

Dirty Copies

Cause	Corrective action

The copy density is too dark. Reduce the copy density. → See page 9.

The exposure glass is dirty. Clean the exposure glass. → See page 53.

Blurred Copies

Cause	Corrective action

The copy density is too light. Increase the copy density. → See page 9.

The toner is running short. Replace the toner cartridge. → See page 43.

Rough, coated, or edged Use only recommended paper.→ See page 5.
paper is used.

The copy paper is damp.	When you copy onto roll paper, cut the damp
	area. → See page 39.

The fusing temperature	is Switch the fusing temperature according to the
not appropriate.	paper type. → See page 7.

Spotty or Partially Blank Copies

Cause	Corrective action
Inappropriate copy paper is Set paper of the same size as, or larger than the
used.	original.

The original feed direction Set the original to match the feed direction of the does not match the paper paper to be copied on.

feed direction.

The leading margin is not Adjust the leading margin. → See page 12. appropriate.

WHAT TO DO IF SOMETHING GOES WRONG 31

Image 38

Contents Operating Instructions Ifor the main switch Introduction Safety InformationSafety During Operation Examples Of IndicationsSafety Information Safety Information Table of Contents What to do if Something Goes Wrong Copier Exterior Main UnitIndicator Panel Operation PanelCopying Basic Recommended OriginalsRecommended Paper Copying Switching the Fusing Temperature Setting the Number of Copies Repeated Copying Adjusting Copy Density Press the Lighter and Darker keys to adjust copy densitySwitching the Copy Exit Copying Setting a Leading/Trailing Edge Margin Copying Copying Onto Roll Paper Synchro CuttingPreset Cutting Copying Variable Cutting Copying Partial Copying Partial Copying Sample Copying Paper TYPE/ROLL Width Entry Function Press the Fusing Temperature key to select the paper type Using the Program Function Programming a Collection of Copy SettingsUsing the Program Function Recalling Programmed Settings Copying with Manual Feed Copying with Manual Feed What to do if Something Goes Wrong When the Wait Indicator is LIT Spotty or Partially Blank Copies Dirty CopiesBlurred Copies Waved Copies Creased CopiesWhen a or x is LIT When a and Are Lit When x and Are Lit What to do if Something Goes Wrong When Is Lit When C is LIT When C is LIT What to do if Something Goes Wrong Cutting the Paper Automatically Cutting the Paper Manually When D is LIT or Blinking When D is LIT or Blinking What to do if Something Goes Wrong Page Maintaining Your Copier Functions That can be Reset Copy MAGNIFICATION/CUT Length Adjustment Copy MAGNIFICATION/CUT Length Adjustment DO’S and DON’TS DO’S and DON’TS Daily Maintenance PAPER/TONER TonerWhere to PUT Your Copier Installation ConditionsSpace Required for Installing the Copier DisposalPower Connection Page Specifications Specifications Spirio 700W3rd Roll Feeder ISOOther Options