Savin 8700W manual Functions That can be Reset

Page 55

FUNCTIONS THAT CAN BE RESET

You can make the copier easier to use by resetting some functions to meet your copying needs. When you want to reset a function, contact your service representative.

You can reset the following functions:

Changing the Auto Reset time

The copier resets itself to the initial settings if it is idle for about 2 minutes during or after copying. This is called "Auto Reset". The auto reset time can be set from 1 to 5 minutes, or it can be turned off.

Copy count up or down

When copying starts, the indicator shows 1 and increments by one each time a copy is made until copying ends. This display can be changed so that it decrements by one (from the set number of copies) to show the number of remaining copies.

Beeper on/off

The beeper heard when the keys are pressed can be disabled.

Disabling the "Auto Image Density" function

By default, the "Auto Image Density" function is used when the copier is turned on. If originals that are not suitable for automatic density adjustment are often copied, the "Auto Image Density" function can be disabled.

Enabling the "lower copy exit"

By default, the "upper copy exit" is selected when the copier is turned on. If paper that is not suitable for the upper copy exit (e.g., A0, 36" × 48" K/ A1, 24"

×26" K) is often used, the "lower copy exit" can be enabled.

Enabling the frequently used paper selection

The frequently used paper selection can be enabled to omit the paper selecting operation when the copier is turned on.

Changing the "Auto Image Density"

If copies consistently come out too dark or too light even when the "Auto Image Density" function is selected, the target density of this function can be changed.

48 MAINTAINING YOUR COPIER

Page 54 Page 56
Image 55
Page 54 Page 56
Contents Operating Instructions Ifor the main switch Examples Of Indications Safety InformationSafety During Operation IntroductionSafety Information Safety Information Table of Contents What to do if Something Goes Wrong Main Unit Copier ExteriorOperation Panel Indicator PanelCopying Recommended Originals BasicRecommended Paper Copying Switching the Fusing Temperature Setting the Number of Copies Repeated Copying Press the Lighter and Darker keys to adjust copy density Adjusting Copy DensitySwitching the Copy Exit Copying Setting a Leading/Trailing Edge Margin Copying Synchro Cutting Copying Onto Roll PaperPreset Cutting Copying Variable Cutting Copying Partial Copying Partial Copying Sample Copying Paper TYPE/ROLL Width Entry Function Press the Fusing Temperature key to select the paper type Programming a Collection of Copy Settings Using the Program FunctionUsing the Program Function Recalling Programmed Settings Copying with Manual Feed Copying with Manual Feed What to do if Something Goes Wrong When the Wait Indicator is LIT Blurred Copies Dirty CopiesSpotty or Partially Blank Copies Creased Copies Waved CopiesWhen a or x is LIT When a and Are Lit When x and Are Lit What to do if Something Goes Wrong When Is Lit When C is LIT When C is LIT What to do if Something Goes Wrong Cutting the Paper Automatically Cutting the Paper Manually When D is LIT or Blinking When D is LIT or Blinking What to do if Something Goes Wrong Page Maintaining Your Copier Functions That can be Reset Copy MAGNIFICATION/CUT Length Adjustment Copy MAGNIFICATION/CUT Length Adjustment DO’S and DON’TS DO’S and DON’TS Daily Maintenance Toner PAPER/TONERInstallation Conditions Where to PUT Your CopierDisposal Space Required for Installing the CopierPower Connection Page Specifications Spirio 700W SpecificationsISO 3rd Roll FeederOther Options
Top Page Image Contents