Savin 8700W manual When a or x is LIT

Page 40

RCaution:

WHEN A OR x IS LIT

A paper jam has occurred. The corrective action varies depending on the location having the misfed paper. Remove the paper according to the corre- sponding instruction shown below.

✏Be sure to remove the paper completely without tearing it. If a piece of the paper remains inside the copier, the paper jam might recur or another fault might occur.

RWARNING: Do not remove any covers or screws other than those specified in this manual. Some parts of the copier are at a

high voltage and could give you an electric shock. When the copier needs to be checked, adjusted or repaired, contact your service representative.

When removing misfed paper, do not touch the fusing section because it could be very hot.

SA location having misfed paper is shown by an indicator on the ope- ration panel.

SSeveral locations might be indicated simultaneously. Remove misfed paper from all of the locations.

SWhen you open the original table, paper path section, or rear cover, the copier turns itself off. However, the copy settings are kept stored.

SWhen you have removed misfed paper, the suspended copy settings are displayed. Resume copying without changing the settings.

SIf paper jams occur repeatedly, contact your service representative.

WHAT TO DO IF SOMETHING GOES WRONG 33

Image 40

Contents Operating Instructions Ifor the main switch Safety Information Safety During OperationIntroduction Examples Of IndicationsSafety Information Safety Information Table of Contents What to do if Something Goes Wrong Copier Exterior Main UnitIndicator Panel Operation PanelCopying Basic Recommended OriginalsRecommended Paper Copying Switching the Fusing Temperature Setting the Number of Copies Repeated Copying Adjusting Copy Density Press the Lighter and Darker keys to adjust copy densitySwitching the Copy Exit Copying Setting a Leading/Trailing Edge Margin Copying Copying Onto Roll Paper Synchro CuttingPreset Cutting Copying Variable Cutting Copying Partial Copying Partial Copying Sample Copying Paper TYPE/ROLL Width Entry Function Press the Fusing Temperature key to select the paper type Using the Program Function Programming a Collection of Copy SettingsUsing the Program Function Recalling Programmed Settings Copying with Manual Feed Copying with Manual Feed What to do if Something Goes Wrong When the Wait Indicator is LIT Blurred Copies Dirty CopiesSpotty or Partially Blank Copies Waved Copies Creased CopiesWhen a or x is LIT When a and Are Lit When x and Are Lit What to do if Something Goes Wrong When Is Lit When C is LIT When C is LIT What to do if Something Goes Wrong Cutting the Paper Automatically Cutting the Paper Manually When D is LIT or Blinking When D is LIT or Blinking What to do if Something Goes Wrong Page Maintaining Your Copier Functions That can be Reset Copy MAGNIFICATION/CUT Length Adjustment Copy MAGNIFICATION/CUT Length Adjustment DO’S and DON’TS DO’S and DON’TS Daily Maintenance PAPER/TONER TonerWhere to PUT Your Copier Installation ConditionsSpace Required for Installing the Copier DisposalPower Connection Page Specifications Specifications Spirio 700W3rd Roll Feeder ISOOther Options